2 layers79.6 × 35 mm
Interfaces and adapters
7,328 boards- 2 layers50 × 38 mm
Flow3r pot
timonsku/flow3r-pot
Helper tool for running UART over USB-C SBU pins for embedded debugging purposes
31 parts1CERN-OHL-P-2.0 - 2 layers110 × 116.3 mm
TOFE Milkymist
timvideos/HDMI2USB-TOFE-Milkymist
A board which adds control interfaces and audio for Milkymist compatibility for use with TOFE-8x hosts like the Numato Opsis.
116 parts1CC-BY-SA-4.0 - 2 layers50 × 52 mm
- 2 layers45 × 21 mm
- 4 layers20.5 × 23 mm
Ublox breakout
TobleMiner/ublox-M8030-KT-breakout
Breakout for the bare UBX-M8030-KT chip. Supports pin compatible chips from M6, M7 and M8 generations. JLCSMT assembly supported
32 parts1 - 2 layers75 × 35 mm
- 2 layers69.2 × 48.3 mm
- 4 layers72.5 × 39.7 mm
FOC RP2350
totaldesaster/SimpleFOC-Serial-Driver
Advanced dual BLDC driver based on the RP2350 and DRV8323S ICs, designed to be controlled from a trajectory controller over RS-485, RS-422 or TTL UART. Features a compact high power design with two stacked PCBs.
68 parts1GPL-3.0 - 2 layers48.4 × 46.1 mm
Solstice
trailcurrentoss/TrailCurrentSolstice
Serial-to-CAN gateway for Victron MPPT solar charge controller data
17 parts1MIT - 2 layers165 × 110 mm
Clean room
trieuhuyduc/Clean_room_slave
ESP32-based slave controller board for cleanroom equipment — RS485/Modbus, isolated I/O, 220V mains control (KiCad)
213 parts1 - 2 layers29 × 29 mm
RTL8710-Breakout
Tylerflick/RTL8710-Breakout
Breakout board and component libraries for RTL8710 (RTL01) module.
10 parts1MIT - 2 layers
Flaps&Speed
ubx/Flaps_and_Speed_Display_HW
A KiCad project for a hardware module designed to interface with flap and speed sensors
15 parts1GPL-3.0 - 2 layers152.4 × 76.2 mm
LiteROV Controller
Urpekari/LiteROV
Light ROV system for educational purposes. 3 Motors, dual H-Bridge drive and JoyC Controls
20 parts1GPL-3.0 - 4 layers100 × 40 mm
RJ45-Board
UTS-48451-NetworkHub/RJ45-Board
RJ45 PCB for Intel Altera Cyclone IV Development Kit
56 parts1 - 4 layers50 × 100 mm
CAN Interface Board
UTS-Rocketry/KESTREL-Control-Board2026
Control Actuation System (CAS) Interface Board for the UTS Rocketry avionics stack.
70 parts1 - 2 layers63.5 × 63.5 mm
- 2 layers53.3 × 34.3 mm
- 6 layers44 × 41.9 mm
Camera breakout board
uwrealitylabs/vitracker-v0
Basic DVP/MIPI camera board made by Miles Milne
67 parts1 - 2 layers32.7 × 32.7 mm
FDC2214-Breakout
VALMAKESTHINGS/FDC2214-Breakout
4 Channel capacitive sensing based on the FDC2214 IC by TI
52 parts1MIT - 2 layers18.6 × 15 mm
- 2 layers84.8 × 62.1 mm
- 2 layers110 × 82 mm
Invertor
victorstoica114/Invertor_board
This repository contains an ESP-IDF firmware for an ESP32 board that bridges, translates, decodes, and exposes battery/inverter communication over CAN and RS485.
151 parts1 - 2 layers57.6 × 53.9 mm
ATtiny85 Arduino programmer
Vincent-Stragier/Creactif-electroLAB
Documents utilisés lors des séances Créactif! dispensées par l'electroLAB.
24 parts1MIT