
Dspic30 simple
Esdras2/dspic30f-devboard-kit
Breadboard-friendly dsPIC30F4011 (DIP-40, all-THT) dev board—KiCad 8 hardware (Rev D) plus XC16 demo firmware, 12 V→5 V regulation, crystal clock & ICSP.

Esdras2/dspic30f-devboard-kit
Breadboard-friendly dsPIC30F4011 (DIP-40, all-THT) dev board—KiCad 8 hardware (Rev D) plus XC16 demo firmware, 12 V→5 V regulation, crystal clock & ICSP.



fandres/pinguino_SMD-2550
PCB in surface mount of the Pinguino board based on the microcontroller PIC18F2550


fernandorasta99/PROYECTO-FINAL
Los puntos a destacar son: Realizar una placa de circuito impreso con los módulos que se utilizarán en el proyecto, para ello, es libre de realizar el diseño como mejor le convenga Puede utilizar cualquier software de…

FETup/ReTrace
ReTrace is a watch mod for the infamous Casio F-91W. Inspired by CarrotIndustries Pluto mod. Borrowed his PCB design as its well done and tested. Replaced the MSP430 controller with PIC24.

ffich/Athena_HW
Repository that contains the Kicad HW project for Athena Pic32 EVB.

finnhittson/PIC32-Breakout-Board
PIC32Flex is a breakout board for the PIC32MX170F256B. This repo holds schematic revision information, how to fabricate this board for yourself, and examples on how to use the board.

finnhittson/RC-Car-Build-Workshop
Table of contents: 1. Design Overview 2. Software 3. Electrical 4. Bill of Materials ## Design Overview The three main components in building this car are the software, electrical, and the mechanical aspect of the car…

Fish-in-a-Barrel/Nixie
This is my Nixie clock project. It was created as an excuse to learn more about electronics and it touches on power circuits, microcontrollers, serial communications, and more.

FranciscoCamara/PCB-Design-Course
Course materials and projects for learning PCB design





g0hjq/PIC12F510_dev
Simple SMD Development PCB for PIC12F510 and other 8-Pin PIC processors


gabrieldelmonte/Board_Bring-Up
Design files and documentation for PBLE02 - Board bring-up and electronic prototype validation, a university project developed at UNIFEI

GerardGascon/fanzine-ds-hardware
This repository is based on LNH-team's DSpico Hardware repository. It removes the microSD card slot and microUSB port from the cartridge in order to make it be a potential reprogramable board for the NDS.

ginomcfino/gas-sensor-breakout
PIC16F18344 gas-sensor board with CO2, oxygen, and air-quality sensing, protected power input, programming, and expansion interfaces. Designed in KiCad.

glm02/projet-vide-cave
Projet GEII vide-cave : carte KiCad G206, analyse, notes Obsidian et visualisation Anatomy. Conception en cours.

GoncaloMark/Turbina
Componente Hardware e Software para Turbinas Tesup carregarem baterias de 12V.
