
Cpiii plasma hdmi
lismarc/compaq-portable-plasma-to-hdmi
Hi, this is Marcin @hawix (father) and Kuba @qbus (son).

lismarc/compaq-portable-plasma-to-hdmi
Hi, this is Marcin @hawix (father) and Kuba @qbus (son).

Litemage/PI4IOE5V6416_Breakout
Breakout board for the Diodes Inc. PI4IOE5V6416 16 channel IO I2C IO expander

liveboxandy/ZX-Interface-1-Narrow-PLCC
ZX Interface 1 recreated with Standard Edge Connector, PLCC ROM with narrow width to not obscure Tape In/Out

lizuyi-6/Networksafe
🛡️ AetherGuard - 智能服务器安全防御平台 | AI + 多Agent协作 + 硬件监控



Llamero/Dual_encoder_controller
Dual encoder controller for hyperspectral display

llatva/hzbugger
Hzbugger, a Black Magic Probe compatible SWD/debugger tool



lnls-sirius/usb-rs485-converter
USB/RS-485 converter based on the FT232RL chip.

Loki045/R1_Robocon_24_Breakout
Breakout and control interface PCB designed for Robocon 2024 R1 robot, supporting Arduino Mega + Host Shield stacking, motor control interfaces, and regulated power distribution from external supply modules.

Loki045/R2_Robocon_24_Breakout_devboard
ESP32-S3 based breakout PCB designed for Robocon 2024 R2 autonomous robot, supporting sensor interfacing, motor control, and rapid testing of navigation and ball-handling mechanisms.

Lonelybarbarian0/stm32-line-follower
An advanced line follower based on STM32f446RE. This design consists of 12 Analog IR sensors (CNY70) , a dual H-bridge driver (TB6612FNG) , has I2C ports for oled display , push buttons , 12V battery accomodation , SWD…

LongHairedHacker/ESP8266-breakout
Breakout board for the ESP8266-03, Chaos InKL version

Loredati-svg/LoRa-USB-Dongle
USB-C LoRa dongle (868 MHz) with STM32WLE5, CP2102N USB-UART bridge and SMA antenna connector. KiCad 10 hardware design: schematic, PCB and libraries.

LoryZhong/3d-volumetric-display-cad
Custom adapter PCB for the 3D volumetric display project, based on and modified from the Active-3 adapter by Henner Zeller (part of the rpi-rgb-led-matrix project).


Luca-Jones/enph-253-pet-rescue
The mechanical design was done with Onshape as our CAD tool. It is simple to use and allows for collaboration and version control.




luishutterli/starbridge
To make it easy for you to get started with GitLab, here's a list of recommended next steps.

LuizFernandoOliveira/Circuito-isolador-de-portas-USB
This work is licensed under a [Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International License][cc-by-nc-nd].