
Teensy-41-true dual canfd lin r11 JARVIS ROUTED CLEAN V2 GND STITCH
monstro-das-bolachas/obdee-wan-canobi
Open-source Dual CAN FD and LIN shield for Teensy 4.1

monstro-das-bolachas/obdee-wan-canobi
Open-source Dual CAN FD and LIN shield for Teensy 4.1

moPsy-project/eurorack-audio-output-breakout
Breakout board for Eurorack Power output on the breadboard


MoriARosland/buck-converter-breakout-3v3
Buck-converter breakout board

Morphdust/microscope_camera_pcb
The carrier PCB for CM5 to sit onto and interface to a Pi HQ camera

mot-prog/avr-programmer
Custom In-System Programmer (ISP) for AVR microcontrollers. Built from scratch with an ATmega16U2, LUFA, and libusb.





mr-foxi/RemiRAT
Custom PCB that condenses my BadArduino project (Arduino Due's SAM, WiPy3.0's ESP32, and a microSD) to a single board. Supports CANBUS, MODBUS-RS485, UART, SPI, I2C. Has USBC connection to SAM.

MrArgon39/SimDrivingCockpit
All the code and other assorted stuff for this project

mrblackchris/GDB_HalfBridge
Half bridge driver using IR2104 for up to 600V DC supplies

mrfitzy/cartreader
For any questions you can use the Discussions and/or Issues section here on GitHub, visit the accompanying thread in the Arduino Forum or check out our community discord server, where you can reach most of the devs…





MrWobot/TemperatureSensorsInterface
A generic board that interfaces to up to 8 thermocouples and speaks over fiber optic uart.


MTalon63/sx1280-breakout
SX1280 LoRa module breakout module to test stuff, as they are only available from chinese sellers



mtrudel/TeensyHID
A simple HID device breakout board for the Teensy family of microcontrollers