
FrontEnd 5G
myriadrf/LimeRFE-8001P
LMS8001 based RF front-end with up/down conversion and predistortion
Printed circuit boards designed in KiCad and published on GitHub, each with its parts, layers and size, its README and its files; open any of them in PCBKit.

myriadrf/LimeRFE-8001P
LMS8001 based RF front-end with up/down conversion and predistortion




naaeell/Mist65
mist65 is a minimalist designed keyboard with 65 layouts, also using a micro controller that is easy to obtain

nacherman/lochraster_Platinen-perfboard_PCBs
Production-ready perfboard PCBs with 2.54mm pitch and integrated GND/VCC power distribution via dual-layer copper zones.


nacs-lab/yyc-data
Both connectors (Camera link an the 2x30 connector to the breakout board) and the decoder chip are on the same (front) side of the board, which is the side that is closer to the FMC connector and the DDS power supply…




namontoy/RobertUN
Exploration Rover, inspired by the NASA's rovers that are exploring Mars. Developed at Universidad Nacional de Colombia - Sede Medellín, with the financial support from a research project.


nandanghawate/arduino-atmega328-custom-hw-sw-projects-NG
This will be / is the collection of sample circuits, PCB layouts, codes and libraries that I will create during the process of exploring ATMEGA328, Arduino - Uno, Nano, Mini


NARAE-INHA-UNIV/LoRa_TM
[2024 UAV 동계 방학] DIY Telemetry Module based Ebyte LoRa


NateOrlowski06/Zenith
A high powered rocketry dual deploy recovery device and data logger.

nathanblanchard-ee/AMD29F_Breakout
Breakout board for an AMD29F flash memory chip from an ECU. Enables programming from a bench due write being disabled on the ECU board.

NautyXie/pcap04-capacitance-readout
KiCad 7 project for the PCAP04 3-channel capacitance readout board. 100 × 100 mm, 4 layers, SMA edge connectors.

ndr-lmnc/regolo
REGOLO an open source 10-channel USB control surface designed for software-based audio volume control.

nebhead/pifire-relay-pwm-module-SSR
This PCB is designed to support SSR relays for controlling incoming Power(L) to the Igniter and Auger. This board also has circuitry to support a 12V PWM fan.


neggles/mpcie-gnss
This is a little miniPCIe card I designed to hold a Quectel LC86L GNSS module, with a timepulse header and a backup supercap.