Boards by CarlosGS

8 boards

Open-source boards designed in KiCad by CarlosGS on GitHub, from 5 repositories. A board’s address here is its repository’s there.

2 layers45.3 × 34.2 mm
Stereo mic amplifier
CarlosGS/OpenBinaural
Low-cost 3D-printable binaural microphone
26 parts72
2 layers48.1 × 120.3 mm
Open rad detector
CarlosGS/Open-Radiation-Detector
Portable radiation detector based on an ionization chamber
34 parts65
2 layers80.8 × 55.4 mm
GNBoard
CarlosGS/GNBot
A 3D-printable robotic platform for testing swarm algorithms
58 parts27
2 layers79.7 × 62.6 mm
OpenReflow
CarlosGS/OpenReflow
Simple reflow oven controller that is configurable from a phone
39 parts25GPL-3.0
2 layers62.2 × 31.7 mm
DTMF Shield
CarlosGS/PrintrCamBot
An open-source Dropcam carrier for Printrbot's challenge
17 parts1
2 layers48.1 × 120.3 mm
Open rad detector
CarlosGS/Open-Radiation-Detector
Portable radiation detector based on an ionization chamber
23 parts65
2 layers20.3 × 21.6 mm
4LDR Board
CarlosGS/GNBot
A 3D-printable robotic platform for testing swarm algorithms
5 parts27
2 layers77.9 × 54.5 mm
GNBoard
CarlosGS/GNBot
A 3D-printable robotic platform for testing swarm algorithms
47 parts27