
RecoveryBoard
psas/lv3.1-recovery
design, analysis, CAD, and testing for the LV3.1 recovery system
Boards in 27 GitHub repositories, designed in KiCad, that use the RC0603FR-0710RL by Unknown maker. See how each wires it, with its parts, size, README and files; the RC0603FR-0710RL’s symbol, footprint and pinout are on its own page.

psas/lv3.1-recovery
design, analysis, CAD, and testing for the LV3.1 recovery system


darshanram008/EMO_OBD_tool
On board diagnostic tool for Battery management system


AndrewCraswell/agency
Native KiCad engineering prototype, separate from the earlier ESP32/tscircuit board. Open usb-scoring-platform.kicadpro in KiCad 10; schematic and PCB are the editable source, with no generator required.

AnotherMike-exe/KiCadBlocks
Reusable KiCad 10 PCB layout blocks: module reference boards, design block fragments and host setup docs


DD1SB/ARDF-TX
Date: 2026-10-15. Engineering review only; unbuilt and unenergized. Open RF80.kicadpro, schematic and native PCB in KiCad10.0.6. Three primary PCBs and the separate VHF true-AM design are unchanged.

gx1400/kicad_foxhunt_batterytest
Custom amateur radio fox hunt (hidden transmitter) controller, aimed at being a flexible, dynamic platform for a wide range of fox-hunt formats — not just a fixed single-mode beacon.


jmercerr/CW312T-ATSAM4L
design transfer project from cw308t to cw312t form for ATSAM4L target board

jmercerr/CW312T-K82F
design transfer project from cw308t to cw312t form for K82F target board

jmercerr/CW312T-MPC5676R
design transfer project from cw308t to cw312t form for MPC5676R target board

Karpuls/E0001-fader-driver-board
Motorized fader driver board (ALPS RSA0N11M9A0J clone): STM32C051, DRV8210P, touch sense, I2C

maurer-lbb/inkube_hardware
Open-source hardware (CAD + PCB) for inkudock, a modular incubator and closed-loop electrophysiology, and a water compartment lid preventing evaporation from cell cultures.

OSE-NZ/keypad-to-can-pcb
PCB to interface a matrix keypad to a CAN bus.



shanebri/ESP32-Supervisor-GNSS-HAT
Raspberry Pi HAT with an ESP32-C6 supervisor, u-blox MAX-M10S GNSS receiver, and HAT ID EEPROM.

utof/eeg_ads1299_lab
It is not a finished EEG recorder, a validated PCB, or permission to attach a circuit to a person. The firmware is a board-dependent bench-only starter using the ADS1299's internal test/short circuits.


clydeshaffer/gametank
design files for the gametank hardware implementation

oresat/oresat-proto-card
Prototype card for the OreSat bus. Requires the OreSat Backplane.

AndrewCraswell/agency
Native KiCad engineering prototype, separate from the earlier ESP32/tscircuit board. Open usb-scoring-platform.kicadpro in KiCad 10; schematic and PCB are the editable source, with no generator required.