4 layers50.8 × 87 mm
4 layers74.5 × 69.2 mm
AFSElec
rice-eclipse/AFSElecECLIPSE: AFS
- Size
- 74.5 × 69.2 mm
- Copper layers
- 4
- Thickness
- 1.6 mm
- Parts
- 117
- Nets
- 96
- Pads
- 438
- Tracks, vias
- 853, 198
- Pours
- 27
- Routed
- Yes
- KiCad
- KiCad 9.0 (file 20241229)
- Created
- 21 Jan 2026
- Updated
- 7 Nov 2026
Overview
AFSElec is an open-source printed circuit board by rice-eclipse, from the rice-eclipse/AFSElec repository on GitHub. It is a 4-layer board of 74.5 × 69.2 mm with 117 parts on 96 nets, routed with 853 tracks and 198 vias.
It is built around the MCS1802GS-50-Z, AP62150WU and MMC5983MA, with the MS5611-01BA03, W25Q128JVSIQ and MSD-4-A among its other parts. Its parts include 40 capacitors, 26 resistors, 15 ICs, 8 connectors and 4 diodes. It belongs with the RP2350 boards of this library.
Main components
11
MCS1802GS-50-Z
SOIC-8Current SensorsMonolithic Power Systems
AP62150WU
TSOT-23-6-40℃~+125℃ 1 1.3MHz 1.5A 135uA 4.2V~18V 800mV~7V Adjustable Buck Buck Built-in Yes TSOT-23-6 DC-DC Converters ROHSDiodes IncorporatedDC-DC Converters
MMC5983MA
LGA-16(3x3)-40℃~+105℃ 18bit 2.8V~3.6V 450uA I2C、SPI ±8Gs ±8Gs LGA-16(3x3) 3D Magnetic Sensors ROHSMEMSIC3D Magnetic Sensors
MS5611-01BA03
QFN-8(3x5)QFN-8(3x5) Pressure Sensors ROHSMEASPressure Sensors
W25Q128JVSIQ
SOIC-8-208mil-40℃~+85℃ 100,000 cycles 120ms@(32KB) 128Mbit 133MHz 1uA 2.7V~3.6V 20 Years 3ms Power-on reset、Hardware write protection、Software write protection、Write enable latch、Absolute write protection SPI SOIC-8-208mil NOR FLASH ROHSWinbondNOR FLASH
MSD-4-A
SMDSMD SD Card / Memory Card Connector ROHSCUISD Card / Memory Card Connector
AMS1117-3.3
SOT-223-40℃~+125℃ 0.003%Vout 1 1.1V@(800mA) 15V 1A 3.3V 5mA 72dB@(120Hz) Fixed Over Current Protection、Short Circuit Protection、Thermal shutdown Positive SOT-223 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSAdvanced Monolithic SystemsVoltage Regulators - Linear, Low Drop Out (LDO) Regulators
ICM-42688-P
LGA-14(2.5x3)-40℃~+85℃ 1.71V~3.6V 16bit 2KB 7.5uA IMU (accelerometer + gyroscope) SPI、I2C X,Y,Z X,Y,Z ±16g ±2000dps Motion Event Detection, Synchronization, Timestamp Support LGA-14(2.5x3) Accelerometers ROHSTDK InvenSenseAccelerometers
KX134-1211
LGA-12(2x2)16bit Accelerometer I2C X,Y,Z ±8g 运动事件检测 LGA-12(2x2) Accelerometers ROHSROHM SemiconductorAccelerometersTPS2121RUXR
VQFN-HR-12(2x2.5)-40℃~+125℃ 2.8V~22V 200uA 56mΩ VQFN-HR-12(2x2.5) ORing Controllers ROHSTexas InstrumentsBattery Management
ABM8-272-T3
SMD3225-4P-40℃~+85℃ 10pF 12MHz 50Ω SMD crystal oscillator ±30ppm ±30ppm SMD3225-4P Crystals ROHSAbraconCrystals
README
README.mdThis is the official GitHub Repo for Rice ECLIPSE AFS.
Parts
117| Qty | Value | Footprint | References |
|---|---|---|---|
| 25 | 100n | Capacitor_SMD:C_0402_1005Metric | C10, C11, C12, C13, C14, C15, C19, C24, C25, C26, C27, C28, C29, C30, C31, C32 +9 |
| 14 | TestPoint | TestPoint:TestPoint_Pad_D1.0mm | 1.1V1, 3v3, BATT_3v3, BATT+, BOOT, GND, GND, ICM_INT, KX_INT, MMC_INT, RST, USB_3.3, VBUS, VIN |
| 6 | 10k | Resistor_SMD:R_0402_1005Metric | R9, R14, R15, R16, R17, R18 |
| 6 | 10u | Capacitor_SMD:C_0805_2012Metric | C18, C20, C21, C23, C37, C39 |
| 5 | Conn_01x03 | Connector_PinHeader_2.54mm:PinHeader_1x03_P2.54mm_Vertical | J3, J4, J5, J6, J9 |
| 4 | 100 | Resistor_SMD:R_0402_1005Metric | R10, R11, R12, R22 |
| 4 | 100k | Resistor_SMD:R_0402_1005Metric | R24, R25, R26, R27 |
| 4 | 4.7u | Capacitor_SMD:C_0402_1005Metric | C1, C2, C3, C4 |
| 4 | MCS1802GS-50-Z | Package_SO:SOIC-8-1EP_3.9x4.9mm_P1.27mm_EP2.29x3mm | U9, U11, U12, U13 |
| 4 | MountingHole | MountingHole:MountingHole_3.2mm_M3_ISO14580_Pad | H1, H2, H3, H4 |
| 3 | 1k | Resistor_SMD:R_0402_1005Metric | R4, R5, R6 |
| 2 | 15p | Capacitor_SMD:C_0402_1005Metric | C16, C17 |
| 2 | 1u | Capacitor_SMD:C_0805_2012Metric | C22, C35 |
| 2 | 22 | Resistor_SMD:R_0402_1005Metric | R2, R3 |
| 2 | 3.3u | otherComponents:AOTA-B201610S3R3-101-T(L_0806_2016metric) | L1, L3 |
| 2 | 4.7k | Resistor_SMD:R_0402_1005Metric | R7, R8 |
| 2 | 47k | Resistor_SMD:R_0402_1005Metric | R19, R20 |
| 2 | RED_LED | LED_SMD:LED_0805_2012Metric | D1, D4 |
| 2 | SW_Push | Button_Switch_SMD:SW_Push_SPST_NO_Alps_SKRK | SW1, SW2 |
| 1 | 15k | Resistor_SMD:R_0402_1005Metric | R21 |
| 1 | 22u | Capacitor_SMD:C_0805_2012Metric | C41 |
| 1 | 2m | Resistor_SMD:R_1206_3216Metric | R13 |
| 1 | 33 | Resistor_SMD:R_0402_1005Metric | R1 |
| 1 | ABM8-272-T3 | Crystal:Crystal_SMD_3225-4Pin_3.2x2.5mm | Y1 |
| 1 | AMS1117-3.3 | Package_TO_SOT_SMD:SOT-223-3_TabPin2 | U3 |
| 1 | AP62150WU | Package_TO_SOT_SMD:TSOT-23-6 | U15 |
| 1 | GREEN_LED | LED_SMD:LED_0805_2012Metric | D3 |
| 1 | ICM-42688-P | Package_LGA:LGA-14_3x2.5mm_P0.5mm_LayoutBorder3x4y | U5 |
| 1 | INA226 | Package_SO:VSSOP-10_3x3mm_P0.5mm | U6 |
| 1 | KX134-1211 | Package_LGA:LGA-12_2x2mm_P0.5mm | U7 |
| 1 | LM75B | Package_SO:SOIC-8-1EP_3.9x4.9mm_P1.27mm_EP2.29x3mm | U10 |
| 1 | LOGO | logos:ECLIPSELogo1 | G*** |
| 1 | MMC5983MA | Package_LGA:LGA-16_3x3mm_P0.5mm | U4 |
| 1 | MS5611-01BA | Package_LGA:LGA-8_3x5mm_P1.25mm | U8 |
| 1 | MSD-4-A | otherComponents:CUI_MSD-4-A | J7 |
| 1 | RP2350A-QFN60 | Package_DFN_QFN:QFN-60-1EP_7x7mm_P0.4mm_EP3.4x3.4mm | U1 |
| 1 | TPS2121RUXR | Package_DFN_QFN:Texas_VQFN-HR-12_2x2.5mm_P0.5mm | U14 |
| 1 | USB_B_Micro | Connector_USB:USB_Micro-B_Amphenol_10118193-0001LF_Horizontal | J1 |
| 1 | W25Q128JVS | Package_SO:SOIC-8_5.3x5.3mm_P1.27mm | U2 |
| 1 | XT60 | Connector_AMASS:AMASS_XT60-M_1x02_P7.20mm_Vertical | J2 |
| 1 | YELLOW_LED | LED_SMD:LED_0805_2012Metric | D2 |
Questions
How big is the AFSElec PCB?
It measures 74.5 × 69.2 mm and has 4 copper layers, 1.6 mm thick.
What parts does the AFSElec use?
117 parts, built around the MCS1802GS-50-Z, AP62150WU, MMC5983MA and MS5611-01BA03. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the AFSElec KiCad files?
From the rice-eclipse/AFSElec repository on GitHub, at the commit this page was made from: the board is Main/Main.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Can I use the AFSElec design in my own project?
Its repository states no licence, so its author keeps all rights: ask rice-eclipse before reusing the design.
More from rice-eclipse/AFSElec
10- 4 layers74.5 × 69.2 mm
- 4 layers74.5 × 69.2 mm
- 4 layers74.5 × 69.2 mm
- 4 layers54.2 × 71.8 mm
- 2 layers
- 2 layers
- 2 layers
- 2 layers
- 2 layers
Similar boards
- 4 layers50.8 × 106.6 mm
- 4 layers67.7 × 97.2 mm
- 4 layers37 × 37 mm
Flight controller
AQUA-Warrior/fpv-drone
Frame needs to be printed using nylon/nylon with carbon fiber only exclusions being ArmAbsorber1-4 and AntenaMount/GPSConnector.
125 parts3CC-BY-SA-4.0 - 4 layers70 × 45 mm
Flight computer
Ben-Blair/Rocket-Build
Senior capstone project: demonstrate closed-loop lateral guidance of a high power rocket using forward canards, and handle the canard-wake-on-aft-fin interference problem correctly.
85 parts - 4 layers55 × 100 mm
CANSAT M2-2026
Engineer162/CANSAT-M2-2026
This repository contains all the sources for a highly advanced CANSAT based on an STM32 MCU and featuring a rechargeable lithium polymer battery.
160 parts - 4 layers66.4 × 66.4 mm
Rera
fdiwth/tvc-drone
This repository contains the documentation, hardware designs, and source code for a Thrust Vector Control (TVC) drone.
140 parts34GPL-3.0 - 4 layers60 × 100 mm
- 4 layers50 × 100 mm
