4 layers35.6 × 17.8 mm
2 layers110.5 × 104.1 mm
Pjc kicad
jdeguire/pjcontrollerHardware and software for controlling your homebuilt video-beaming creation.
- Size
- 110.5 × 104.1 mm
- Copper layers
- 2
- Thickness
- 1.6 mm
- Parts
- 89
- Nets
- 54
- Pads
- 277
- Tracks, vias
- 526, 26
- Pours
- 5
- Routed
- Yes
- KiCad
- KiCad 3
- Created
- 5 Nov 2010
- Updated
- 8 Jun 2013
Overview
Pjc kicad is an open-source printed circuit board by jdeguire, from the jdeguire/pjcontroller repository on GitHub, published under the GPL-3.0 licence. It is a 2-layer board of 110.5 × 104.1 mm with 89 parts on 54 nets, routed with 526 tracks and 26 vias.
It is built around the ATMEGA328-PU, SN74LVC1G07DBV and NUD3124L, with the FT232RL, MCP3301-CI/P and BSP762T among its other parts. Its parts include 19 resistors, 14 capacitors, 10 ICs, 10 connectors and 5 fuses. It belongs with the AVR (ATmega, ATtiny) boards of this library.
Main components
9
ATMEGA328-PU
PDIP-28-40℃~+85℃ 1.8V~5.5V 10bit 1KB 20MHz 23 2KB 32KB 8 Bit AVR Built-in FLASH PDIP-28 Microcontrollers (MCU/MPU/SOC) ROHSMicrochip TechnologyMicrocontrollers (MCU/MPU/SOC)
SN74LVC1G07DBV
SOT-23-5-40℃~+125℃ 1 1 1.65V~5.5V 10uA 32mA 4.2ns@3.3V,50pF 74LVC Open-drain Power-off isolation、Level shifting Unidirectional SOT-23-5 Buffers, Drivers, Receivers, Transceivers ROHSTexas InstrumentsBuffers / Drivers
NUD3124L
SOT-23-40℃~+125℃ 1 1.4Ω 200mA SOT-23 Relay / Coil Drivers ROHSonsemiBrushed DC Motor Drivers
FT232RL
SSOP-28-208mil-40℃~+85℃ 3.3V~5.25V、4V~5.25V USB 2.0 USB to UART SSOP-28-208mil USB Converters ROHSFTDIUSB Converters
MCP3301-CI/P
PDIP-8-40℃~+85℃ 100kHz 13 2LSB 4.5V~5.5V 50nA 78dB 85kHz~1.7MHz、1.7MHz Not supported SAR SPI Yes PDIP-8 Analog to Digital Converters (ADC) ROHSMicrochip TechnologyAnalog To Digital Converters (ADC)
BSP762T
SO-8-40℃~+150℃ 1 100mΩ 2A 5V~34V Active High High Side Switch 过压保护、欠压锁定、反向电压保护、集成电荷泵、Overcurrent Protection、Over temperature protection、Short-Circuit Protection SO-8 Power Distribution Switches ROHSInfineon TechnologiesPower Distribution Switches
L78M05CV
TO-2200℃~+150℃@(Tj) 1 2V 35V 40uV 500mA 5V 62dB@(120Hz) 6mA Fixed Over Current Protection、Over Temperature Protection、Short Circuit Protection Positive TO-220 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSSTMicroelectronicsVoltage Regulators - Linear, Low Drop Out (LDO) RegulatorsVOM618A-4T
SOP-4-55℃~+110℃ 1 1.1V 120mV@1mA,0.25mA 160% 170mW 3.75kV 320% 4us 50mA 5us 60mA 6V 80V DC Phototransistor SOP-4 Transistor, Photovoltaic Output Optoisolators ROHSVishay IntertechnologyTransistor, Photovoltaic Output Optoisolators
S1M
SMA(DO-214AC)-65℃~+150℃ 1 Independent 1.1V@1A 1A 1kV 5uA@1kV SMA(DO-214AC) Diodes - General Purpose ROHSDiodes IncorporatedDiodes - General Purpose
Parts
89| Qty | Value | Footprint | References |
|---|---|---|---|
| 15 | TST | PINTST | TP1, TP2, TP3, TP4, TP5, TP8, TP9, TP10, TP11, TP12, TP13, TP14, TP15, TP16, TP17 |
| 11 | 10k | SM1206_LP | R2, R3, R4, R6, R8, R10, R12, R15, R16, R17, R18 |
| 8 | 100nF | SM1206_LP | C2, C4, C5, C6, C7, C8, C9, C14 |
| 5 | 120mA | SM1206_LP | F1, F2, F3, F4, F5 |
| 4 | CONN_2 | MINI_CT_2_PTH | CON6, CON7, CON9, CON10 |
| 4 | MNT_HOLE_NPT | MNT_HOLE_4x10mm | MH1, MH2, MH3, MH4 |
| 3 | 3.3k | SM1206_LP | R1, R9, R19 |
| 2 | 22pF | SM1206_LP | C12, C13 |
| 2 | NUD3124 | SOT23-6_LP | U8, U10 |
| 1 | 1.5k | SM1206_LP | R13 |
| 1 | 10nF | SM1206_LP | C1 |
| 1 | 10uF | SM1206_LP | C10 |
| 1 | 1k | SM1206_LP | R7 |
| 1 | 1uF | SM1206_LP | C11 |
| 1 | 2.2k | SM1206_LP | R14 |
| 1 | 20MHz | XTAL_SMD | X1 |
| 1 | 20k | SM1206_LP | R5 |
| 1 | 4.7uF | SM1206_LP | C3 |
| 1 | 470 | SM1206_LP | R11 |
| 1 | 4PIN_FAN_CONN | 4PIN_FAN_PTH | CON5 |
| 1 | ATMEGA328-P | DIP-28_SOCK | U5 |
| 1 | AVR-ISP-10 | AVR_ISP_PTH | CON8 |
| 1 | BSP762T | SOIC8_LP | U4 |
| 1 | CONN_2 | JST_PH_2_PTH | CON3 |
| 1 | CONN_3 | MINI_CT_3_PTH | CON2 |
| 1 | FT232RL | SSOP28_LP | U3 |
| 1 | Green | SM1206_DIODE_LP | D2 |
| 1 | INDUCTOR_SMALL | SM1206_LP | L1 |
| 1 | JUMPER-2PTH | PIN_ARRAY_2X1 | JP1 |
| 1 | L78M05C | DPAK_VREG_LP | U7 |
| 1 | M023.5MM | SCREWTERM-3.5MM-2 | CON4 |
| 1 | MCP3301 | SOIC8_LP | U2 |
| 1 | MOSFET_P | SOT23GDS_LP | Q1 |
| 1 | OSHW_LOGO_400mil | OSHW_LOGO_400mil | G*** |
| 1 | RSQ045N03 | SOT23-6_LP | Q2 |
| 1 | Red | SM1206_DIODE_LP | D4 |
| 1 | S1M | SMA-DIODE_LP | D1 |
| 1 | SN74LVC1G07 | SOT23-5_LP | U6 |
| 1 | SWITCH_INV | SWITCH_SPDT_LP | SW1 |
| 1 | TAC_SWITCHSMD | TACTILE-SW-PTH | S1 |
| 1 | TMP36_SOIC | SOIC8_LP | U9 |
| 1 | USB-MINI-B | USB_MINI_B_LP | CON1 |
| 1 | VOM618A-4T | SOP-4_LP | U1 |
| 1 | Yellow | SM1206_DIODE_LP | D3 |
Questions
How big is the Pjc kicad PCB?
It measures 110.5 × 104.1 mm and has 2 copper layers, 1.6 mm thick.
What parts does the Pjc kicad use?
89 parts, built around the ATMEGA328-PU, SN74LVC1G07DBV, NUD3124L and FT232RL. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the Pjc kicad KiCad files?
From the jdeguire/pjcontroller repository on GitHub, at the commit this page was made from: the board is hardware/pjc-kicad/pjc-kicad.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Can I use the Pjc kicad design in my own project?
Its repository publishes it under the GPL-3.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).
Similar boards
- 2 layers
- 2 layers121.3 × 120.9 mm
Erun2
immonel/e-runout
This project is used to measure electrical runout by comparing measurements from touching probe sensors and Eddy current probes simultaneously.
38 parts - 2 layers24.8 × 86.4 mm
Raspberry pico board Back
Jan-IngenHousz-Institute/spectrometer-C12666MA
Repository for the fw and analysis developed during the internship of Kjell Tolsma.
16 parts - 2 layers75 × 65 mm
Motormodul
Meo98/picostack
Stackable, contract-driven module system for the Raspberry Pi Pico — open hardware, built by code
63 partsGPL-3.0 - 2 layers121.9 × 61 mm
- 4 layers75 × 50 mm
- 2 layers41 × 51 mm
