Skip to the content

Boards by emtpb

6 boards

Open-source boards designed in KiCad by emtpb on GitHub, from 6 repositories. A board’s address here is its repository’s there.

  • 2 layers166 × 28 mmEt ruler lauflicht, the printed circuit board in 3D

    Et ruler lauflicht

    emtpb/et-ruler-lauflicht

    PCB with a handy ruler, can be populated with a chasing light circuit

    37 parts1
  • 2 layers166 × 28 mmEt ruler litac, the printed circuit board in 3D

    Et ruler litac

    emtpb/et-ruler-litac

    PCB with a handy ruler, can be populated with a circuit that converts light to audio

    27 parts1
  • 2 layers23.3 × 53.3 mmPico hw rgb, the printed circuit board in 3D

    Pico hw rgb

    emtpb/pico-hw-rgb

    RGB LED extension board for Raspberry Pi Pico

    20 parts
  • 2 layers64.8 × 20.3 mmPmi hw alice, the printed circuit board in 3D

    Pmi hw alice

    emtpb/pmi-hw-alice

    This pcb is designed for the course PMI (Practical course Microcontroller and Interface electronics) to model crossroads with traffic lights. It uses an I2C port expander to drive several leds.

    37 parts
  • 2 layers54.6 × 87.6 mmPmi hw bob2, the printed circuit board in 3D

    Pmi hw bob2

    emtpb/pmi-hw-bob2

    This pcb is designed for the course PMI (Practical course Microcontroller and Interface electronics) as a breakout board for right morpho connector (CN10) of STM32 Nucleo-64 boards.

    58 parts
  • 2 layers54.6 × 20.3 mmPmi hw carlos, the printed circuit board in 3D

    Pmi hw carlos

    emtpb/pmi-hw-carlos

    This pcb is designed for the course PMI (Practical course Microcontroller and Interface electronics). It features two buttons and a simple capacitor load / discharge circuit.

    19 parts