Boards by custom-ds

6 boards

Open-source boards designed in KiCad by custom-ds on GitHub, from 5 repositories. A board’s address here is its repository’s there.

2 layers50.1 × 88.2 mm
PtFlex
custom-ds/ptFlex
ptFlex tracker board starting with version 2.0 of the hardware, which is based on the improvements found in the ptSolar tracker.
76 parts3GPL-3.0
2 layers17.4 × 53.1 mm
PtConfig
custom-ds/ptConfig
A configuration cable for the ptFlex, ptSolar, and ptSolarHF trackers, capable of configuring and supplying power.
13 partsGPL-3.0
4 layers38.5 × 73.5 mm
PtSolar
custom-ds/ptSolar
Under the hood, the ptSolar runs on the same Microchip ATMega328p microcontroller that the other trackers have been using for years, although this board runs at a lower 3.3 volt level, and a slower 8MHz clock speed.
70 partsGPL-3.0
2 layers30 × 52 mm
Raspi ir
custom-ds/Universal-Remote-LIRC
Build a universal remote control using a Raspberry Pi with the LIRC library
32 partsGPL-3.0
2 layers62 × 83 mm
Vehicle Power Switch
custom-ds/Vehicle-Auto-On
With the Arduion programmer board loaded with the jtag2updi software, and the Pin 6 from the Arduino connected to the Reset line on the ATTiny404, you can Build and Program directly inside of the Visual Studio Code.
49 partsGPL-3.0
2 layers24.5 × 73.5 mm
PtSolar Breakout
custom-ds/ptSolar
Under the hood, the ptSolar runs on the same Microchip ATMega328p microcontroller that the other trackers have been using for years, although this board runs at a lower 3.3 volt level, and a slower 8MHz clock speed.
18 partsGPL-3.0

PtFlex