2 layers50 × 57 mm
2 layers72 × 47 mm
LED driver
xtompok/LED_driver3x5A PWM driver for LED strips
- Size
- 72 × 47 mm
- Copper layers
- 2
- Thickness
- 1.6 mm
- Parts
- 96
- Nets
- 80
- Pads
- 333
- Tracks, vias
- 1,065, 106
- Pours
- 9
- Routed
- Yes
- KiCad
- KiCad 5 (file 20171130)
- Created
- 3 Jan 2020
- Updated
- 6 Nov 2024
Overview
LED driver is an open-source printed circuit board by xtompok, from the xtompok/LED_driver repository on GitHub, published under the MIT licence. It is a 2-layer board of 72 × 47 mm with 96 parts on 80 nets, routed with 1,065 tracks and 106 vias.
It is built around the SN65HVD3082EDR, ZXGD3009E6TA and BY25Q16BSTIG(R), with the MIC5504-3.3YM5, YJD80G06A and BZT52C15 among its other parts. Its parts include 36 resistors, 21 capacitors, 11 ICs, 11 connectors and 8 diodes. It belongs with the STM32 boards of this library.
Main components
8
SN65HVD3082EDR
SOP-8-40℃~+85℃ 1 1 12Mbps 3.3V 32 425uA Enable shutdown、Overcurrent Protection、Thermal shutdown protection、Tx/Rx enable Half-Duplex Transceiver ±8kV SOP-8 RS-485 / RS-422 ICs ROHSJSMSEMIRS-485 / RS-422 ICs
ZXGD3009E6TA
SOT-26-55℃~+150℃ 1 20nA 210ns 240ns 2A 2A 40V Interleaved conduction protection Low Side MOSFET SOT-26 Gate Drivers ROHSDiodes IncorporatedGate DriversBY25Q16BSTIG(R)
SOP-8-40℃~+85℃ 100,000 cycles 108MHz 16Mbit 2.7V~3.6V 20 Years 5uA 600us Power-on reset、Hardware Write Protection、Software Write Protection、Write enable latch、Absolute Write Protection SPI SOP-8 NOR FLASH ROHSBOYAMICRONOR FLASH
MIC5504-3.3YM5
SOT-23-5-40℃~+125℃@(Tj) 1 120uVrms 15uA 180mV@(300mA) 3.3V 300mA 5.5V 75dB@(1kHz) Fixed Over Temperature Protection、Enable Positive SOT-23-5 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSTECH PUBLICVoltage Regulators - Linear, Low Drop Out (LDO) Regulators
YJD80G06A
TO-252-55℃~+150℃ 1 N-channel 1.525nF 11mΩ@4.5V 13.5pF 2.5V 31nC@10V 372pF 60V 78W 80A N-Channel TO-252 MOSFETs ROHSYangzhou Yangjie Electronic TechnologyMOSFETs
BZT52C15
SOD-123-65℃~+150℃ 1 Independent 100nA@1V 13.8V~15.6V 15V 200Ω 30Ω 370mW SOD-123 Zener Diodes ROHSDiodes IncorporatedZener Diodes
SE60P20B
TO-252-55℃~+150℃ 1 P-Channel 1.25nF 170W 180nC@10V 2.5V 20A 3.5nF 33mΩ@10V 450pF 60V P-Channel TO-252 MOSFETs ROHSSINO-ICMOSFETs
STPS160A
SMA(DO-214AC)1 Independent 1A 4uA@60V 60V 670mV@1A 75A SMA(DO-214AC) Schottky Diodes ROHSSTMicroelectronicsSchottky Diodes
Parts
96| Qty | Value | Footprint | References |
|---|---|---|---|
| 13 | 100n | Capacitor_SMD:C_0603_1608Metric | C1, C2, C10, C11, C16, C20, C21, C30, C31, C51, C61, C71, C81 |
| 5 | 10k | Resistor_SMD:R_0603_1608Metric | R1, R2, R6, R7, R12 |
| 5 | 1k | Resistor_SMD:R_0603_1608Metric | R33, R52, R62, R72, R82 |
| 5 | 4k7 | Resistor_SMD:R_0603_1608Metric | R28, R51, R61, R71, R81 |
| 4 | 1u | Capacitor_SMD:C_0603_1608Metric | C5, C6, C8, C13 |
| 4 | 330R | Resistor_SMD:R_0603_1608Metric | R24, R25, R26, R27 |
| 3 | 0.01R | Resistor_SMD:R_1206_3216Metric | R11, R21, R31 |
| 3 | 100R | Resistor_SMD:R_0603_1608Metric | R10, R20, R30 |
| 3 | INA180A2 | Package_TO_SOT_SMD:SOT-23-5 | U11, U21, U31 |
| 3 | YJD80G06A | Package_TO_SOT_SMD:TO-252-2 | Q10, Q20, Q30 |
| 3 | ZXGD3009E6 | Package_TO_SOT_SMD:SOT-23-6 | U10, U20, U30 |
| 2 | 1k5 | Resistor_SMD:R_0603_1608Metric | R8, R9 |
| 2 | 27p | Capacitor_SMD:C_0603_1608Metric | C4, C7 |
| 2 | 33k | Resistor_SMD:R_0603_1608Metric | R4, R23 |
| 2 | 720R | Resistor_SMD:R_0603_1608Metric | R34, R36 |
| 2 | MountingHole_Pad | MountingHole:MountingHole_3.2mm_M3_Pad_Via | H1, H2 |
| 1 | 10n | Capacitor_SMD:C_0603_1608Metric | C9 |
| 1 | 120R | Resistor_SMD:R_0603_1608Metric | R35 |
| 1 | 150k | Resistor_SMD:R_0603_1608Metric | R5 |
| 1 | 1M | Resistor_SMD:R_0603_1608Metric | R3 |
| 1 | 1k2 | Resistor_SMD:R_0603_1608Metric | R29 |
| 1 | 2u2 | Capacitor_SMD:C_0603_1608Metric | C12 |
| 1 | 560R | Resistor_SMD:R_0603_1608Metric | R32 |
| 1 | 8MHz | Crystal:Crystal_HC49-U_Vertical | Y1 |
| 1 | ADC_EXT | Connector_Molex:Molex_KK-254_AE-6410-04A_1x04_P2.54mm_Vertical | J10 |
| 1 | AP2204K-5.0 | Package_TO_SOT_SMD:SOT-23-5 | U2 |
| 1 | BUTTONS | Connector_Molex:Molex_Micro-Fit_3.0_43045-0800_2x04_P3.00mm_Horizontal | J9 |
| 1 | BY25Q16BSTIG | Package_SO:SOP-8_3.9x4.9mm_P1.27mm | U4 |
| 1 | BZT52C15 | Diode_SMD:D_SOD-123F | D1 |
| 1 | I2C | Connector_Molex:Molex_KK-254_AE-6410-04A_1x04_P2.54mm_Vertical | J8 |
| 1 | LED_EN | Connector_PinHeader_2.54mm:PinHeader_1x02_P2.54mm_Vertical | J11 |
| 1 | LED_STRIPS | Connector_Molex:Molex_Micro-Fit_3.0_43045-0600_2x03_P3.00mm_Horizontal | J2 |
| 1 | L_12V | LED_SMD:LED_PLCC-2 | D8 |
| 1 | L_RX | LED_SMD:LED_PLCC-2 | D6 |
| 1 | L_TX | LED_SMD:LED_PLCC-2 | D5 |
| 1 | L_U1 | LED_SMD:LED_PLCC-2 | D3 |
| 1 | L_U2 | LED_SMD:LED_PLCC-2 | D4 |
| 1 | L_VCC | LED_SMD:LED_PLCC-2 | D7 |
| 1 | MIC5504-3.3YM5 | Package_TO_SOT_SMD:SOT-23-5 | U1 |
| 1 | NTCC-22k | Capacitor_THT:C_Disc_D3.8mm_W2.6mm_P2.50mm | TH1 |
| 1 | POWER | Connector_Phoenix_MSTB:PhoenixContact_MSTB_2,5_3-GF-5,08_1x03_P5.08mm_Horizontal_ThreadedFlange | J3 |
| 1 | PROG | Connector_Molex:Molex_KK-254_AE-6410-05A_1x05_P2.54mm_Vertical | J1 |
| 1 | RS485_1 | LED_driver:PTSA_1.5_3-3.5-Z_1985205 | J6 |
| 1 | RS485_2 | LED_driver:PTSA_1.5_3-3.5-Z_1985205 | J7 |
| 1 | RST | Connector_PinHeader_2.54mm:PinHeader_1x02_P2.54mm_Vertical | J5 |
| 1 | SE60P20B | Package_TO_SOT_SMD:TO-252-2 | Q1 |
| 1 | SINGLE_POWER | Connector_PinHeader_2.54mm:PinHeader_1x02_P2.54mm_Vertical | J4 |
| 1 | SN65HVD3082EDR | Package_SO:SOP-8_3.9x4.9mm_P1.27mm | U5 |
| 1 | STM32F030C8Tx | Package_QFP:LQFP-48_7x7mm_P0.5mm | U3 |
| 1 | STPS160A | Diode_SMD:D_SMA | D2 |
| 1 | TestPoint | TestPoint:TestPoint_THTPad_D2.0mm_Drill1.0mm | TP1 |
More from xtompok/LED_driver
2- 2 layers60 × 65 mm
Similar boards
- 4 layers255.9 × 224.5 mm
Central control unit
RomLab/pcb-system-for-underfloor-heating-v2.0
PCB for underfloor heating system
1,880 parts1 - 2 layers80 × 100 mm
- 4 layers107.5 × 102.5 mm
- 2 layers50 × 44 mm
Baseboard
xtompok/home_automation_switchboard
Board fitting into wall switch, support for 1Wire, quadrature encoder, and much more. RS-485
82 partsMIT - 2 layers35 × 35 mm
- 2 layers58.4 × 66.7 mm
PWM10
Duckle29/PWM-Solar-Charge-Controller
A PWM Solar Charge controller based on Julian Lietts PWM5
55 parts9MIT - 2 layers77 × 73.5 mm
EChook Nano
eChook/eChook-Nano-PCB
Designspark Schematics and PCB files, and PCB Gerber Files
141 parts2 - 4 layers220 × 130 mm
Gantry controller prototype DUE
kitspace-forks/growbox-open-motion-mobo
A general purpose open source Arduino DUE based motion controller designed to run the Synthetos G2 motion control fimware
138 parts
Questions
How big is the LED driver PCB?
It measures 72 × 47 mm and has 2 copper layers, 1.6 mm thick.
What parts does the LED driver use?
96 parts, built around the SN65HVD3082EDR, ZXGD3009E6TA, BY25Q16BSTIG(R) and MIC5504-3.3YM5. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the LED driver KiCad files?
From the xtompok/LED_driver repository on GitHub, at the commit this page was made from: the board is hw/LED_driver.kicad_pcb and its schematic hw/LED_driver3/LED_driver3.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Can I use the LED driver design in my own project?
Its repository publishes it under the MIT licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).