
Laser sensor
prusa3d/PRUSA_Laser_filament_sensor
Filament presence and velocity detection using a PAT9125EL optical laser movement sensor, operating at 850nm.

Filament presence and velocity detection using a PAT9125EL optical laser movement sensor, operating at 850nm.
Laser sensor is an open-source printed circuit board by prusa3d, from the prusa3d/PRUSA_Laser_filament_sensor repository on GitHub. It is a 2-layer board of 22 × 10 mm with 13 parts on 10 nets, routed with 109 tracks and 6 vias.
It is built around the LSF0102DP. Its parts include 4 capacitors, 3 resistors, 3 ICs, 1 connector and 1 fuse. It belongs with the sensors and measurement boards of this library.
Filament presence and velocity detection using a PAT9125EL optical laser movement sensor, operating at 850nm.
See also:

| Qty | Value | Footprint | References |
|---|---|---|---|
| 2 | 4k7 | Resistors_SMD:R_0603 | R1, R2 |
| 2 | 4u7 | Capacitors_SMD:C_0603 | C1, C4 |
| 1 | 100n | Capacitors_SMD:C_0603 | C3 |
| 1 | 10u | Capacitors_SMD:C_0603 | C2 |
| 1 | 200k | Resistors_SMD:R_0603 | R3 |
| 1 | 50mA | Resistors_SMD:R_1206 | F1 |
| 1 | CONN_01X04 | Pin_Headers:Pin_Header_Angled_1x04 | P1 |
| 1 | LSF0102 | ok1hra:LSF0102 | U3 |
| 1 | MCP1703T | TO_SOT_Packages_SMD:SOT-23 | U2 |
| 1 | PAT9125EL | ok1hra:PAT9125EL | U1 |
The 12 most common of 13 parts.

prusa3d/PRUSA_Laser_filament_sensor
Filament presence and velocity detection using a PAT9125EL optical laser movement sensor, operating at 850nm.

xyphro/I3CBlaster
Raspberry pico / RP2040 based USB to I3C converter with Python support

RemiFM/USB-LiDAR-VL53L9
USB accessory device with VL53L9 Time of Flight sensor (dToF 3D LiDAR) & 6-axis IMU


vgacentrifuge/pcb
The repository for designing the PCB for the VGA-mixer in TDT4295

MagGenix/AMF-Generator
A digitally controlled push-pull converter designed for generation of an alternating magnetic field (AMF). THIS DESIGN IS INCOMPLETE.

msharp176/LoRa-Water-Quality-Management-System
Repository for the LoRa Water Quality Management System, Penn State Harrisburg Senior Electrical Engineering Capstone Design Course, Fall 2025


It measures 22 × 10 mm and has 2 copper layers, 1.6 mm thick.
13 parts, built around the LSF0102DP. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the prusa3d/PRUSA_Laser_filament_sensor repository on GitHub, at the commit this page was made from: the board is rev.02e/laser-sensor.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask prusa3d before reusing the design.