
Marine gps
mbouyer/marine_chartplotter
Hardware and software for an opencpn-based chartplotter

Hardware and software for an opencpn-based chartplotter
Connect board is an open-source printed circuit board by mbouyer, from the mbouyer/marine_chartplotter repository on GitHub, published under the BSD-2-Clause licence. It is a 2-layer board of 61 × 34.3 mm with 11 parts on 14 nets, routed with 45 tracks and 0 vias.
It is built around the JUMPER3. It belongs with the interfaces and adapters boards and the PIC boards of this library.
Hardware and software for an opencpn-based chartplotter The kardware has been designed with kicad 4.0.x The chartplotter is built around a A20-based single-board computer from Olimex (https://www.olimex.com/Products/OLinuXino/A20/A20-OLinuXIno-LIME2/) and a 15" TFT full HD display also from Olimex (https://www.olimex.com/Products/OLinuXino/LCD/LCD-OLinuXino-15.6FHD)
The hardware consist of 4 boards
for more details see the wiki: https://github.com/mbouyer/marine_chartplotter/wiki
| Qty | Value | Footprint | References |
|---|---|---|---|
| 2 | CONN_01X03 | FS_Terminal_Blocks:TerminalBlock_Pheonix_MPT-2.54mm_3pol | P4, P5 |
| 2 | CONN_01X04 | phoenix-local:phoenix_1770979 | P1, P2 |
| 2 | JUMPER3 | FS_Pin_Headers:Pin_Header_Straight_1x03 | JP1, JP2 |
| 1 | HE10-10 | local:he10s-10d | P3 |
The 7 most common of 11 parts.

mbouyer/marine_chartplotter
Hardware and software for an opencpn-based chartplotter

mbouyer/marine_chartplotter
Hardware and software for an opencpn-based chartplotter

mbouyer/marine_chartplotter
Hardware and software for an opencpn-based chartplotter

mbouyer/marine_chartplotter
Hardware and software for an opencpn-based chartplotter

Ardumower/ardumower
Develop an open source robotic lawn mower (HW+SW reference platform)

Teslafly/Dead-OpenBMS-dead
A scalable, open source battery management system






whitebox-labs/tentacle
An arduino shield to host and individually isolate up to 4 Atlas Scientific sensor circuits. Measure pH, conductivity, dissolved oxygen, ORP, temperature
It measures 61 × 34.3 mm and has 2 copper layers, 1.6 mm thick.
11 parts, built around the JUMPER3. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the mbouyer/marine_chartplotter repository on GitHub, at the commit this page was made from: the board is hardware/connect_board.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the BSD-2-Clause licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).