2 layers19 × 106 mm
2 layers49.5 × 106 mm
Supra board
jsenzel1/supra4is multimode Eurorack module with 4 different experiments in long term time. you can run up to 2 modes at once. use the 4 way joystick and buttons to interact with the modes on the oled
- Size
- 49.5 × 106 mm
- Copper layers
- 2
- Thickness
- 1.6 mm
- Parts
- 119
- Nets
- 112
- Pads
- 397
- Tracks, vias
- 1,249, 134
- Pours
- 1
- Routed
- Yes
- KiCad
- KiCad 8.0 (file 20240108)
- Created
- 17 Nov 2025
- Updated
- 30 Oct 2026
Overview
Supra board is an open-source printed circuit board by jsenzel1, from the jsenzel1/supra repository on GitHub. It is a 2-layer board of 49.5 × 106 mm with 119 parts on 112 nets, routed with 1,249 tracks and 134 vias.
It is built around the OPA1679ID, W25Q128JVSIQ and MCP4728-E/UN, with the LD1117S33CTR-HXY, PCF8523T and SM4001 among its other parts. Its parts include 46 resistors, 27 capacitors, 18 diodes, 11 connectors and 5 ICs. It belongs with the RP2350 boards of this library.
Main components
7
OPA1679ID
SOIC-14-18V~-2.25V、2.25V~18V、4.5V~36V -40℃~+85℃ 0.0001% 2.5mA 4-Channel ESD protection SOIC-14 Audio Amplifiers ROHSTexas InstrumentsAudio Amplifiers
W25Q128JVSIQ
SOIC-8-208mil-40℃~+85℃ 100,000 cycles 120ms@(32KB) 128Mbit 133MHz 1uA 2.7V~3.6V 20 Years 3ms Power-on reset、Hardware write protection、Software write protection、Write enable latch、Absolute write protection SPI SOIC-8-208mil NOR FLASH ROHSWinbondNOR FLASH
MCP4728-E/UN
MSOP-10-40℃~+125℃ 12 2.7V~5.5V 2LSB 4 40nA 6us I2C Integrated buffer、Power-on reset、Power-down mode、Programmable gain Voltage Buffer MSOP-10 Digital to Analog Converters (DAC) ROHSMicrochip TechnologyDigital To Analog Converters (DAC)
LD1117S33CTR-HXY
SOT-223-20℃~+85℃ 1.3V@(800mA) 15V 2mA 3.3V 800mA Fixed Over Temperature Protection SOT-223 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSHXY MOSFETVoltage Regulators - Linear, Low Drop Out (LDO) Regulators
PCF8523T
SOIC8Real-Time Clock (RTC) and calendarNXP SemiconductorsUncategorised
SM4001
DO-213AB-50℃~+175℃ 1 Independent 1.1V@1A 1A 44A 50V 5uA@50V DO-213AB Diodes - General Purpose ROHSDIOTECDiodes - General PurposeJS5208
SMDSMD Pushbutton Switches ROHSE-SwitchPushbutton Switches
README
README.mdSUPRA
is multimode Eurorack module with 4 different experiments in long term time. you can run up to 2 modes at once. use the 4 way joystick and buttons to interact with the modes on the oled
Parts
119| Qty | Value | Footprint | References |
|---|---|---|---|
| 17 | 100n | Capacitor_SMD:C_0402_1005Metric | C1, C2, C3, C4, C15, C17, C18, C19, C20, C21, C22, C23, C24, C28, C30, C31 +1 |
| 11 | 1k | Capacitor_SMD:C_0402_1005Metric | R1, R4, R5, R6, R9, R10, R13, R14, R17, R20, R28 |
| 8 | BAT43W-V | Diode_SMD:D_SOD-323 | D10, D11, D12, D13, D14, D15, D16, D17 |
| 4 | 100K | Capacitor_SMD:C_0402_1005Metric | R37, R38, R40, R42 |
| 4 | 100k | Capacitor_SMD:C_0402_1005Metric | R2, R8, R12, R16 |
| 4 | 10u | Capacitor_SMD:C_0402_1005Metric | C10, C11, C12, C29 |
| 4 | 3.3k | Resistor_SMD:R_0402_1005Metric | R32, R34, R43, R44 |
| 4 | 4.7u | Capacitor_SMD:C_0402_1005Metric | C16, C25, C26, C27 |
| 4 | 400k | Capacitor_SMD:C_0805_2012Metric | R3, R7, R11, R15 |
| 4 | 470 | Capacitor_SMD:C_0402_1005Metric | R35, R36, R39, R41 |
| 4 | AudioJack2 | Connector_Audio:_Jack_3.5mm_QingPu_JACK_ANCHOR | J6, J7, J9, J10 |
| 3 | 10K | Capacitor_SMD:C_0402_1005Metric | R30, R31, R33 |
| 2 | 100r | Resistor_SMD:R_0402_1005Metric | R46, R47 |
| 2 | 10k | Capacitor_SMD:C_0402_1005Metric | R21, R22 |
| 2 | 27 | Resistor_SMD:R_0402_1005Metric | R24, R25 |
| 2 | 27p | Capacitor_SMD:C_0402_1005Metric | C8, C9 |
| 2 | 5.1k | Capacitor_SMD:C_0402_1005Metric | R18, R19 |
| 2 | 5819 | Diode_SMD:D_SOD-123 | D1, D2 |
| 2 | DNF | Resistor_SMD:R_0402_1005Metric | R26, R27 |
| 2 | R2 | LED_SMD:LED_PLCC_2835 | D5, D7 |
| 2 | SM4001 | Diode_SMD:D_SOD-123 | D3, D4 |
| 2 | SMD0805P010TF polyfuse | Fuse:Fuse_0805_2012Metric | F1, F2 |
| 1 | 1k | Resistor_SMD:R_0402_1005Metric | R29 |
| 1 | 3.3u | RP2350_60QFN_minimal:L_pol_2016 | L1 |
| 1 | 33 | Resistor_SMD:R_0402_1005Metric | R23 |
| 1 | Battery_Cell | Battery:BatteryHolder_Keystone_3000_1x12mm | BT1 |
| 1 | Conn_02x05 | Connector_PinHeader_2.54mm:PinHeader_2x05_P2.54mm_Vertical | J4 |
| 1 | Crystal DST310S 32.768KHz | Crystal:Crystal_SMD_3215-2Pin_3.2x1.5mm | Y2 |
| 1 | JS5208 | sw_nav_5waySUPRA:sw_nav_5waySUPRA | S1 |
| 1 | L1 | LED_SMD:LED_PLCC_2835 | D8 |
| 1 | L2 | LED_SMD:LED_PLCC_2835 | D6 |
| 1 | LD1117S33CTR | Package_TO_SOT_SMD:SOT-89-3 | U2 |
| 1 | Lselect | LED_SMD:LED_PLCC_2835 | D18 |
| 1 | MCP4728 | Package_SO:MSOP-10_3x3mm_P0.5mm | DAC1 |
| 1 | OLED DISP | Connector_PinSocket_2.54mm:PinSocket_1x04_P2.54mm_Vertical | J5 |
| 1 | OPA1679 | Package_SO:SOIC-14_3.9x8.7mm_P1.27mm | U7 |
| 1 | PCF8523T | Package_SO:SOIC-8_3.9x4.9mm_P1.27mm | U3 |
| 1 | RP2350_60QFN | RP2350_60QFN_minimal:RP2350-QFN-60-1EP_7x7_P0.4mm_EP3.4x3.4mm_ThermalVias | U6 |
| 1 | Rselect | LED_SMD:LED_PLCC_2835 | D19 |
| 1 | USB_C_Receptacle_USB2.0 | Connector_USB:USB_C_Receptacle_G-Switch_GT-USB-7010ASV | J3 |
| 1 | W25Q128JVS | W25Q16JVUXIQ:SON50P300X200X60-9N | U5 |
| 1 | X322512MSB4SI (mini 12MhZ crystal) | Crystal:Crystal_SMD_3225-4Pin_3.2x2.5mm | Y1 |
| 1 | btnA | Button_Switch_THT:SW_PUSH_6mm | SW2 |
| 1 | btnB | Button_Switch_THT:SW_PUSH_6mm | SW3 |
| 1 | btnBOOT | Button_Switch_THT:SW_PUSH_6mm | SW1 |
| 1 | btnHand | Button_Switch_THT:SW_PUSH_6mm | SW4 |
| 1 | out 1 | Connector_Audio:_Jack_3.5mm_QingPu_JACK_ANCHOR | J14 |
| 1 | out 2 | Connector_Audio:_Jack_3.5mm_QingPu_JACK_ANCHOR | J2 |
| 1 | out 3 | Connector_Audio:_Jack_3.5mm_QingPu_JACK_ANCHOR | J1 |
| 1 | out 4 | Connector_Audio:_Jack_3.5mm_QingPu_JACK_ANCHOR | J8 |
Questions
How big is the Supra board PCB?
It measures 49.5 × 106 mm and has 2 copper layers, 1.6 mm thick.
What parts does the Supra board use?
119 parts, built around the OPA1679ID, W25Q128JVSIQ, MCP4728-E/UN and LD1117S33CTR-HXY. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the Supra board KiCad files?
From the jsenzel1/supra repository on GitHub, at the commit this page was made from: the board is hardware/board final for public/supra_board.kicad_pcb and its schematic hardware/board final for public/supra_board.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Can I use the Supra board design in my own project?
Its repository states no licence, so its author keeps all rights: ask jsenzel1 before reusing the design.
Similar boards
- 2 layers
- 6 layers60.6 × 100 mm
Gecko5education
logisim-evolution/GECKO5Education
Openhardware educational platform based on the ideas of the ulx3s and Gecko4Education
311 parts18MIT - 4 layers81.4 × 60 mm
- 2 layers113.7 × 79.3 mm
- 2 layers120 × 130 mm
SingularitySurfer V1
nkrackow/SingularitySurfer-FPGA-Lock-In-Amplifier
Repository for the development of an FPGA based DSP Lock-In Amplifier
174 parts80MIT - 4 layers75 × 36 mm
EmoeNAP
Floyd-Fish/Noise-Amplifier
An ultra-low noise amplifier to measure low-noise LDO/OPA's wide band output noise, and many other interesting measurements. Referred to AN-159.
189 parts36GPL-3.0 - 2 layers46 × 20 mm
