
Stepper driver
harp-tech/device.stepperdriver
A stepper motor controller device for four motors including individual quadrature encoders.

A stepper motor controller device for four motors including individual quadrature encoders.
Stepper driver rear panel is an open-source printed circuit board by harp-tech, from the harp-tech/device.stepperdriver repository on GitHub. It is a 2-layer board of 133 × 35 mm with 3 parts on 9 nets.
It is built around the USB4105-GF-A. It belongs with the robots and motor control boards of this library.
A stepper motor controller device for four motors including individual quadrature encoders..
The interface with the Harp Behavior can be done through Bonsai
Each subdirectory will contain a license or, possibly, a set of licenses if it involves both hardware and software.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 1 | USB4105-GF-A | Connector_USB:USB_C_Receptacle_GCT_USB4105-xx-A_16P_TopMnt_Horizontal | J4 |
The 1 most common of 3 parts.

harp-tech/device.stepperdriver
A stepper motor controller device for four motors including individual quadrature encoders.

harp-tech/device.stepperdriver
A stepper motor controller device for four motors including individual quadrature encoders.



iandchasse/silkscreen-pcb
Silkscreen: open-hardware ESP32-S3 e-paper reader mainboard (KiCad 9). Formerly the de-link hub.


StuckAtPrototype/AirCube
Works standalone out of the box. Pairs with Home Assistant in minutes. Other platforms are supported through community-contributed extensions.



It measures 133 × 35 mm and has 2 copper layers, 1.6 mm thick.
3 parts, built around the USB4105-GF-A. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the harp-tech/device.stepperdriver repository on GitHub, at the commit this page was made from: the board is Hardware/PCB/stepper driver rear panel/stepper driver rear panel.kicad_pcb and its schematic Hardware/PCB/stepper driver front panel/stepperdriver front panel.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask harp-tech before reusing the design.