Skip to the content

Boards by MIsfitMatty

6 boards

Open-source boards designed in KiCad by MIsfitMatty on GitHub, from 4 repositories. A board’s address here is its repository’s there.

  • 2 layers80 × 80 mmMAP1, the printed circuit board in 3D

    MAP1

    MIsfitMatty/MAP1_MPXreplacement

    83 partsGPL-3.0
  • 2 layers78.7 × 105.2 mmCore4GPZ rev0-1, the printed circuit board in 3D

    Core4GPZ rev0-1

    MIsfitMatty/Speeduino-2Wheel-prototype

    It's build around the DIY-EFI's CORE4 board, with a custom "Daughter board", and use the Speeduino firmware. The CORE4 board is current choice for it's compact footprint, and fully featured board.

    51 partsCERN-OHL-S-2.0
  • 4 layers100 × 100 mmSpeeday, the printed circuit board in 3D

    Speeday

    MIsfitMatty/Speeduino-Daytona

    223 parts
  • 2 layers20.3 × 26 mmIgnition Coil Driver, the printed circuit board in 3D

    Ignition Coil Driver

    MIsfitMatty/Speeduino-2Wheel-prototype

    It's build around the DIY-EFI's CORE4 board, with a custom "Daughter board", and use the Speeduino firmware. The CORE4 board is current choice for it's compact footprint, and fully featured board.

    5 partsCERN-OHL-S-2.0
  • 2 layers16.3 × 18.8 mmVoltage converter, the printed circuit board in 3D

    Voltage converter

    MIsfitMatty/Speeduino-2Wheel-prototype

    It's build around the DIY-EFI's CORE4 board, with a custom "Daughter board", and use the Speeduino firmware. The CORE4 board is current choice for it's compact footprint, and fully featured board.

    11 partsCERN-OHL-S-2.0