12V SmartSwitch 2panel

Device Drivers --->
	USB Support --->
		USB Serial Converter Support --->
			<M>   USB CP210x family of UART Bridge Controllers  

Dec 31 17:57:51 nautilus kernel: usb 1-2.4: new full-speed USB device number 35 using ehci-pci
Dec 31 17:57:51 nautilus kernel: usb 1-2.4: New USB device found, idVendor=10c4, idProduct=ea60, bcdDevice= 1.00
Dec 31 17:57:51 nautilus kernel: usb 1-2.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Dec 31 17:57:51 nautilus kernel: usb 1-2.4: Product: CP2102N USB to UART Bridge Controller
Dec 31 17:57:51 nautilus kernel: usb 1-2.4: Manufacturer: VintLabs
Dec 31 17:57:51 nautilus kernel: usb 1-2.4: SerialNumber: 0002
Dec 31 17:57:51 nautilus kernel: cp210x 1-2.4:1.0: cp210x converter detected
Dec 31 17:57:51 nautilus kernel: usb 1-2.4: cp210x converter now attached to ttyUSB0

// PWM Example for VintLabs ESP32 PWM Driver DevKit
// Connect an LED light from PWM0 on the board to ground (if using a discrete LED use a current limiting series resistor!)

// Select the PWM output to use - you can use PWM0-PWM7 for the VintLabs boards, or simply specify the GPIO number
const int pwmOutput = PWM0;

// Set the PWM frequency
const int frequency = 10000;

// Set the LED channel. Note that this is not related to a pin number, but an arbitrary channel number from 0-7
const int ledChannel = 0;

// Set the resolution. This can be 8, 10, 12 or 15 bits
const int resolution = 12;


void setup() {
  // Basic PWM setup
  ledcSetup(ledChannel, frequency, resolution);

  // Attach the actual output to the channel
  ledcAttachPin(pwmOutput, ledChannel);

}