2 layers65 × 56 mm
Dingo hat
CCHS-Melbourne/dingo-cap
Donkey-Hat is a Raspberry Pi Hat to drive a Donkey Car (http://www.donkeycar.com/)
98 parts
4 layers65 × 73 mm
AutonomousSeedDistributor
jason-shepherd/AutonomousSeedDistributorPCB- Size
- 65 × 73 mm
- Copper layers
- 4
- Thickness
- 1.6 mm
- Parts
- 104
- Nets
- 164
- Pads
- 459
- Tracks, vias
- 834, 161
- Pours
- 13
- Routed
- Yes
- KiCad
- KiCad 9.0 (file 20241229)
- Created
- 11 Oct 2025
- Updated
- 17 Nov 2025
Overview
AutonomousSeedDistributor is an open-source printed circuit board by jason-shepherd, from the jason-shepherd/AutonomousSeedDistributorPCB repository on GitHub. It is a 4-layer board of 65 × 73 mm with 104 parts on 164 nets, routed with 834 tracks and 161 vias.
It is built around the STM32F091RCT6, AOZ6605PI-1 and INA226AQDGSRQ1, with the L298HN, MIC5219-3.3YMM and BSS138 among its other parts. Its parts include 32 resistors, 28 capacitors, 13 connectors, 11 transistors and 9 ICs. It belongs with the STM32 boards of this library.
Main components
8
STM32F091RCT6
LQFP-64(10x10)-40℃~+85℃ 12bit 12bit 256KB 2V~3.6V 32 Bit 32KB 48MHz 52 ARM Cortex-M0 Built-in FLASH LQFP-64(10x10) Microcontrollers (MCU/MPU/SOC) ROHSSTMicroelectronicsMicrocontrollers (MCU/MPU/SOC)
AOZ6605PI-1
ESOP-8-40℃~+85℃ 1 250uA 4.5V~18V 5A 600kHz Adjustable Buck Buck Built-in Yes ESOP-8 DC-DC Converters ROHSAlpha & Omega SemiconductorDC-DC Converters
INA226AQDGSRQ1
VSSOP-10-0.5mm-40℃~+125℃ 0.1uV/℃ 0V~36V 10mA 10nA 140dB 2.5uV 2.7V~5.5V 330uA High-side detection、Low-side detection、Power monitoring、Digital output interface、Programmable threshold alarm ±40V VSSOP-10-0.5mm Current Sense Amplifiers ROHSTexas InstrumentsSupervisor And Reset ICs
L298HN
Multiwatt-15Active braking function Multiwatt-15 Brushed DC Motor Drivers ROHSSTMicroelectronicsGate Drive ICs
MIC5219-3.3YMM
MSOP-8-40℃~+125℃ 1 12V 3.3V 500mA 600mV@(500mA) 75dB@(120Hz) Fixed Over Current Protection、Over Temperature Protection、Enable Positive MSOP-8 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSMicrochip TechnologyVoltage Regulators - Linear, Low Drop Out (LDO) Regulators
BSS138
SOT-23-55℃~+150℃ 1 N-channel 1.1Ω@10V、1.2Ω@4.5V 1.2V 1.7nC@10V 17.5pF 340mA 350mW 50V 6.5pF N-Channel SOT-23 MOSFETs ROHShongjiachengMOSFETs
DMP3013SFV
PowerDI3333-8-55℃~+150℃ 1 P-Channel 1.674nF 1.94W 17mΩ@4.5V 230pF 30V 33.7nC@10V 35A 3V P-Channel PowerDI3333-8 MOSFETs ROHSDiodes IncorporatedMOSFETsMF-RHT1000-0
插件-40℃~+85℃ 15mΩ 5.3W 6.2mΩ 插件 Resettable Fuses ROHSBournsResettable Fuses
Parts
104| Qty | Value | Footprint | References |
|---|---|---|---|
| 18 | 10kR | Resistor_SMD:R_0603_1608Metric | R1, R2, R3, R4, R5, R6, R7, R10, R11, R12, R13, R14, R15, R16, R17, R19 +2 |
| 14 | 0.1uF | Capacitor_SMD:C_0603_1608Metric | C4, C5, C6, C7, C11, C12, C16, C18, C23, C24, C25, C26, C27, C28 |
| 10 | BSS138 | Package_TO_SOT_SMD:SOT-23 | Q1, Q2, Q3, Q4, Q5, Q6, Q7, Q8, Q9, Q11 |
| 4 | 1uF | Capacitor_SMD:C_0603_1608Metric | C1, C2, C15, C21 |
| 4 | Conn_01x04 | Connector_PinHeader_2.54mm:PinHeader_1x04_P2.54mm_Vertical | J2, J3, J6, J8 |
| 4 | MountingHole | MountingHole:MountingHole_2.7mm | H1, H2, H3, H4 |
| 2 | 10R | Resistor_SMD:R_0603_1608Metric | R22, R24 |
| 2 | 4.7kR | Resistor_SMD:R_0603_1608Metric | R25, R26 |
| 2 | 47pF | Capacitor_SMD:C_0603_1608Metric | C19, C20 |
| 2 | 5.1kR | Resistor_SMD:R_0603_1608Metric | R31, R32 |
| 2 | 5pF | Capacitor_SMD:C_0603_1608Metric | C9, C10 |
| 2 | Conn_01x06 | Connector_JST:JST_PH_B6B-PH-K_1x06_P2.00mm_Vertical | J4, J5 |
| 1 | 100R | Resistor_SMD:R_0603_1608Metric | R18 |
| 1 | 100kR | Resistor_SMD:R_0603_1608Metric | R21 |
| 1 | 10uF | Capacitor_SMD:C_0603_1608Metric | C8 |
| 1 | 110kR | Resistor_SMD:R_0603_1608Metric | R28 |
| 1 | 15kR | Resistor_SMD:R_0603_1608Metric | R29 |
| 1 | 18VWM29.2VC1 | Diode_SMD:D_SOD-123 | D2 |
| 1 | 2.2kR | Resistor_SMD:R_0603_1608Metric | R30 |
| 1 | 2.2nF | Capacitor_SMD:C_0603_1608Metric | C17 |
| 1 | 20kR | Resistor_SMD:R_0603_1608Metric | R27 |
| 1 | 22uF | Capacitor_SMD:C_0603_1608Metric | C13 |
| 1 | 33nF | Capacitor_SMD:C_0603_1608Metric | C14 |
| 1 | 3V | ML414H_IV01E:SEIKO_ML414H_IV01E | BT1 |
| 1 | 4.7uH | 74437377047:WE-LHMI_1335 | L2 |
| 1 | 45V16A1 | Package_TO_SOT_THT:TO-220-2_Vertical | D1 |
| 1 | 470pF | Capacitor_SMD:C_0603_1608Metric | C3 |
| 1 | 50kR | Resistor_SMD:R_0603_1608Metric | R20 |
| 1 | 6.8nH | Inductor_SMD:L_0603_1608Metric | L1 |
| 1 | 60uF | Capacitor_SMD:C_0603_1608Metric | C22 |
| 1 | 7.5mR | Resistor_SMD:R_2512_6332Metric | R23 |
| 1 | AOZ6605PI-1 | AOZ6605PI-1:SO8_EP1_AOS | U8 |
| 1 | AP2127K-1.8 | Package_TO_SOT_SMD:SOT-23-5 | U1 |
| 1 | Antenna | Connector_Coaxial:U.FL_Molex_MCRF_73412-0110_Vertical | J1 |
| 1 | Battery holes | 1984617(1):PHOENIX_1984617 | J12 |
| 1 | CM7V-T1A-32.768kHz-7pF | Crystal:Crystal_SMD_3215-2Pin_3.2x1.5mm | Y1 |
| 1 | Conn_01x02 | 1984617(1):PHOENIX_1984617 | J9 |
| 1 | Conn_01x03_Pin | Connector_PinHeader_2.54mm:PinHeader_1x03_P2.54mm_Vertical | J7 |
| 1 | Conn_01x04_Pin | Connector_PinHeader_2.54mm:PinHeader_1x04_P2.54mm_Vertical | J11 |
| 1 | Conn_02x20_Odd_Even | Connector_PinSocket_2.54mm:PinSocket_2x20_P2.54mm_Vertical | J10 |
| 1 | DMP3013SFV | Package_SON:Diodes_PowerDI3333-8 | Q10 |
| 1 | INA226AQDGSRQ1 | Package_SO:VSSOP-10_3x3mm_P0.5mm | U7 |
| 1 | L298HN | Package_TO_SOT_THT:TO-220-15_P2.54x2.54mm_StaggerOdd_Lead5.84mm_TabDown | U5 |
| 1 | MF-RHT1000 | Fuse:Fuse_Bourns_MF-RHT1000 | F1 |
| 1 | MIC5219-3.3YMM | Package_SO:MSOP-8_3x3mm_P0.65mm | U9 |
| 1 | STM32F091RCT6 | Package_QFP:LQFP-64_10x10mm_P0.5mm | U6 |
| 1 | USB_C_Receptacle | Connector_USB:USB_C_Receptacle_Amphenol_12401610E4-2A | J13 |
| 1 | ~ | Package_DFN_QFN:QFN-24-1EP_3x3mm_P0.4mm_EP1.75x1.6mm | U3 |
| 1 | ~ | jshep:uDFN-6 | U2 |
| 1 | ~ | jshep:LCC-18 | U4 |
Similar boards
- 2 layers115.3 × 171.5 mm
PurdueFall2023ECE477Team2
AdenKoperczak/PurdueFall2023ECE477Team2
Code and other files for a portable Skee-Ball Machine
140 parts - 2 layers10.3 × 11 mm
- 2 layers60 × 64 mm
LCDPCB
Ashassins/NYAKB
ECE 477 Project: NYAKB is a multimedia keyboard with hot swappable modules
33 parts2 - 4 layers150 × 137.1 mm
Controller
CircuitGuy943/Sabre-Integrated-flight-controller
(🚧) A "Jack of all trades" custom flight controller board. With support for both power and control and the ability for custom firmware
282 parts2GPL-3.0 - 4 layers88.1 × 59.4 mm
Chromapi motherboard v1
Mowibox/chromapi_motherboard
Raspberry Pi control HAT dedicated to the quadruped robot Chromapi.
139 parts2Apache-2.0 - 4 layers83 × 67.5 mm
MarineBoard
Cadburies/SisuAssistant
Sailing yacht Sisu: Home Assistant + ESPHome Marine Board (alternator regulation, tanks) + MQTT kernel, Signal K/Grafana/InfluxDB on a NAS, and Sisu Nav chart & weather-routing cockpit.
162 parts1Apache-2.0 - 2 layers45 × 45 mm
Questions
How big is the AutonomousSeedDistributor PCB?
It measures 65 × 73 mm and has 4 copper layers, 1.6 mm thick.
What parts does the AutonomousSeedDistributor use?
104 parts, built around the STM32F091RCT6, AOZ6605PI-1, INA226AQDGSRQ1 and L298HN. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the AutonomousSeedDistributor KiCad files?
From the jason-shepherd/AutonomousSeedDistributorPCB repository on GitHub, at the commit this page was made from: the board is AutonomousSeedDistributor.kicad_pcb and its schematic AutonomousSeedDistributor.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Can I use the AutonomousSeedDistributor design in my own project?
Its repository states no licence, so its author keeps all rights: ask jason-shepherd before reusing the design.