
DangerDonut
gavin4d/dangerDonut
Danger Donut is a work-in-progress 150 gram melty brain combat robot.
Danger Donut is a work-in-progress 150 gram melty brain combat robot.
Beacon is an open-source printed circuit board by gavin4d, from the gavin4d/dangerDonut repository on GitHub. It is a 2-layer board of 15.2 × 24.1 mm with 19 parts on 11 nets, routed with 34 tracks and 13 vias.
It is built around the ATTINY85-20SU. Its parts include 2 resistors, 1 capacitor, 1 IC and 1 diode. It belongs with the AVR (ATmega, ATtiny) boards of this library.

Danger Donut is a work-in-progress 150 gram melty brain combat robot.
This repository contains:
Links:
| Qty | Value | Footprint | References |
|---|---|---|---|
| 8 | TestPoint | TestPoint:TestPoint_Pad_D1.0mm | GND, P0, P1, P2, P3, P4, P5, VCC |
| 2 | 47 | Resistor_SMD:R_0805_2012Metric_Pad1.20x1.40mm_HandSolder | R1, R2 |
| 1 | |||
| 1 | 1 uF | Capacitor_SMD:C_0805_2012Metric_Pad1.18x1.45mm_HandSolder | C1 |
| 1 | ATtiny85-20S | Package_SO:SOIC-8W_5.3x5.3mm_P1.27mm | U1 |
| 1 | Battery | batteryConnector:3Pin 2.5MM Spring Contact | BT1 |
| 1 | LED | LED_THT:LED_D3.0mm_Clear | D1 |
| 1 | R_Potentiometer | Potentiometer_THT:Potentiometer_Piher_PC-16_Single_Vertical | RV1 |
The 16 most common of 19 parts.

gavin4d/dangerDonut
Danger Donut is a work-in-progress 150 gram melty brain combat robot.

SensorsIot/SuperPower
Here you should find the best power supplies for your low-power projects

KivApple/dell-charger-emulator
Emulator of original Dell charger using ATTINY85


bwack/C64-Saver-bwack
C64 Saver v1 and v2 - Overvoltage protection for the C64 and its power brick.


valerionew/very-good-uc-doggos
A special graduation present for a special friend. Six microcontrollers in one devboard


spielhuus/LoRa-Environmental-Sensors
ATtiny85 based LoRa atmospheric sensor board with BME280
It measures 15.2 × 24.1 mm and has 2 copper layers, 1.6 mm thick.
19 parts, built around the ATTINY85-20SU. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the gavin4d/dangerDonut repository on GitHub, at the commit this page was made from: the board is PCB/Beacon/Beacon.kicad_pcb and its schematic PCB/Beacon/Beacon.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask gavin4d before reusing the design.