

ControlBoard
Giove 8k audio synthesizer project
- Size
- 410.2 × 181.6 mm
- Copper layers
- 2
- Thickness
- 1.6 mm
- Parts
- 247
- Nets
- 235
- Pads
- 1,000
- Tracks, vias
- 1,379, 3
- Pours
- 4
- Routed
- Yes
- KiCad
- KiCad 5 (file 20171130)
- Created
- 2 Feb 2022
- Updated
- 30 Jul 2024
Overview
ControlBoard is an open-source printed circuit board by andreaslagler, from the andreaslagler/giove8k repository on GitHub, published under the GPL-3.0 licence. It is a 2-layer board of 410.2 × 181.6 mm with 247 parts on 235 nets, routed with 1,379 tracks and 3 vias.
It is built around the ATMEGA328P-PU, 74HC595 and 25LC512-I/P, with the 74AHC04D, 74HC138 and LM1117-5.0 among its other parts. Its parts include 61 resistors, 47 diodes, 29 capacitors, 24 ICs and 24 switches. It belongs with the audio and music boards and the AVR (ATmega, ATtiny) boards of this library.
Main components
6ATMEGA328P-PU
DIP-28-300mil-40℃~+85℃ 1.8V~5.5V 10bit 1KB 20MHz 23 2KB 32KB 8 Bit AVR Built-in FLASH DIP-28-300mil Microcontrollers (MCU/MPU/SOC) ROHSMicrochip TechnologyMicrocontrollers (MCU/MPU/SOC)74HC595
SOP-16-40℃~+85℃ 1 100ns@5V,50pF 10MHz 2V~6V 74HC 8 Serial-to-Serial or Parallel Tri-State SOP-16 Shift Registers ROHSGRShift Registers25LC512-I/P
PDIP-8-40℃~+85℃ 1,000,000 cycles 2.5V~5.5V 200 Years 20MHz 512Kbit 5ms Hardware write protection function、Built-in power-on reset (POR)、Built-in write enable latch (WEL)、Power-down/Power-up protection circuit SPI PDIP-8 EEPROM ROHSMicrochip TechnologyEEPROM74AHC04D
SOIC-14-40℃~+125℃ 1 1.5V~3.85V 1.9V、2.9V、4.4V 2V~5.5V 2uA 500mV~1.65V 6 7.5ns@5V,50pF 74AHC 8mA 8mA SOIC-14 Inverters ROHSNexperiaInverters74HC138
SOP-160℃~+70℃ 24ns@5.0V,16pF 2V~6V 3/8 5.2mA 5.2mA 5uA 74HC Decoder Reverse function Single Supply SOP-16 Signal Switches, Multiplexers, Decoders ROHSGRSignal Switches, Multiplexers, DecodersLM1117-5.0
SOT-2231 1.3V@(1000mA) 15V 1A 2mA 5V Fixed Over Current Protection、Short Circuit Protection、Thermal shutdown Positive SOT-223 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHShongjiachengUncategorised
README
README.mdgiove8k
Giove 8k audio synthesizer project
Parts
247| Qty | Value | Footprint | References |
|---|---|---|---|
| 46 | 1k5 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R10, R11, R12, R13, R14, R15, R16, R17, R18, R19, R20, R21, R22, R25, R26, R27 +30 |
| 46 | LED | LED_THT:LED_D3.0mm | D2, D10, D11, D12, D13, D14, D15, D18, D19, D20, D21, D22, D23, D24, D25, D26 +30 |
| 38 | 10kB | Potentiometer_THT:Potentiometer_Alpha_RD901F-40-00D_Single_Vertical_CircularHoles | RV1, RV2, RV10, RV11, RV12, RV13, RV14, RV15, RV16, RV17, RV18, RV19, RV20, RV21, RV22, RV23 +22 |
| 24 | 100n | Capacitor_THT:C_Disc_D5.0mm_W2.5mm_P5.00mm | C1, C10, C11, C12, C13, C14, C15, C16, C17, C18, C19, C20, C21, C22, C23, C24 +8 |
| 18 | SW_Push | Button_Switch_THT:SW_PUSH-12mm | SW2, SW3, SW4, SW5, SW16, SW17, SW18, SW19, SW20, SW21, SW22, SW23, SW27, SW28, SW29, SW30 +2 |
| 7 | 74HC595 | Package_DIP:DIP-16_W7.62mm | U12, U13, U14, U15, U16, U17, U18 |
| 5 | 100 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R59, R60, R63, R66, R67 |
| 5 | 220 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R2, R5, R6, R7, R8 |
| 5 | 4051 | Package_DIP:DIP-16_W7.62mm | U7, U8, U9, U10, U11 |
| 5 | RotEnc | Rotary_Encoder:RotaryEncoder_Alps_EC12E_Vertical_H20mm_CircularMountingHoles | SW8, SW9, SW24, SW25, SW26 |
| 3 | 10k | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R1, R4, R57 |
| 3 | 25LC512 | Package_DIP:DIP-8_W7.62mm | U19, U22, U23 |
| 2 | 10u | Capacitor_THT:CP_Radial_D5.0mm_P2.50mm | C26, C27 |
| 2 | 22p | Capacitor_THT:C_Disc_D3.0mm_W1.6mm_P2.50mm | C2, C3 |
| 2 | Conn_01x02_Male | Connector_Molex:Molex_KK-254_AE-6410-02A_1x02_P2.54mm_Vertical | J8, J9 |
| 2 | Conn_01x03_Male | Connector_Molex:Molex_KK-254_AE-6410-03A_1x03_P2.54mm_Vertical | J10, J11 |
| 2 | MCP23S17_SP | Package_DIP:DIP-28_W7.62mm | U3, U4 |
| 2 | MCP6002-xP | Package_DIP:DIP-8_W7.62mm | U21, U24 |
| 1 | 100k | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R58 |
| 1 | 100u | Capacitor_THT:CP_Radial_D8.0mm_P5.00mm | C25 |
| 1 | 10k | Potentiometer_THT:Potentiometer_Piher_PT-6-V_Vertical | RV41 |
| 1 | 20 MHz | Crystal:Crystal_HC49-U_Vertical | Y1 |
| 1 | 22kA | Potentiometer_THT:Potentiometer_Alpha_RD902F-40-00D_Dual_Vertical_CircularHoles | RV39 |
| 1 | 2N3904 | Package_TO_SOT_THT:TO-92 | Q1 |
| 1 | 470 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R3 |
| 1 | 6N138 | Package_DIP:DIP-8_W7.62mm | U5 |
| 1 | 6VDC | Connector_Molex:Molex_KK-254_AE-6410-02A_1x02_P2.54mm_Vertical | J7 |
| 1 | 74AHC04 | Package_DIP:DIP-14_W7.62mm | U6 |
| 1 | 74HC138 | Package_DIP:DIP-16_W7.62mm | U2 |
| 1 | ATMEGA328P-PU | Package_DIP:DIP-28_W7.62mm | U1 |
| 1 | AVR-ISP-6 | Connector_IDC:IDC-Header_2x03_P2.54mm_Vertical | J1 |
| 1 | Conn_01x04_Male | Connector_PinHeader_2.54mm:PinHeader_1x04_P2.54mm_Vertical | J5 |
| 1 | Conn_01x06_Male | Connector_PinHeader_2.54mm:PinHeader_1x06_P2.54mm_Vertical | J6 |
| 1 | D | Diode_THT:D_A-405_P10.16mm_Horizontal | D1 |
| 1 | LM1117-5.0 | Package_TO_SOT_THT:TO-220-3_Vertical | U20 |
| 1 | MIDI In | Connector_Molex:Molex_KK-254_AE-6410-02A_1x02_P2.54mm_Vertical | J2 |
| 1 | MIDI Out | Connector_Molex:Molex_KK-254_AE-6410-02A_1x02_P2.54mm_Vertical | J4 |
| 1 | MIDI Thru | Connector_Molex:Molex_KK-254_AE-6410-02A_1x02_P2.54mm_Vertical | J3 |
| 1 | SW_Push | Button_Switch_THT:SW_PUSH_6mm | SW1 |
| 1 | WC1602A | Display:WC1602A | DS1 |
The 239 most common of 247 parts.
More from andreaslagler/giove8k
1- 2 layers137.2 × 116.8 mm

Similar boards
- 2 layers99.1 × 88.9 mm

1002 EPROM EMU NG 2.2d
Kris-Sekula/EPROM-EMU-NG
EPROM Emulator Project with Arduino
49 parts161Apache-2.0 - 2 layers209 × 175 mm

Excalibur64
Cptscorcher/Excallibur-64
A reimagining of the seminal Excalibur 64 Computer
126 partsGPL-3.0 - 2 layers295 × 195 mm

- 2 layers115 × 143 mm

- 6 layers313 × 259.5 mm

Open8-vga motherboard
adham404/Open8-VGA
An 8-bit computer from 74HC logic: microcoded CPU, VGA, PS/2, on-board editor and assembler. Play it in your browser.
322 parts3MIT - 4 layers76 × 76.9 mm

- 4 layers200 × 50 mm

- 2 layers51.4 × 57.2 mm

Memory
depletionmode/cupc8
Then run kernel/debug.sh. The guest display is embedded by default; use kernel/debug.sh --display:window for the standalone SDL window. Terminal graphics and color treatment can be selected explicitly:
13 parts2
Questions
How big is the ControlBoard PCB?
It measures 410.2 × 181.6 mm and has 2 copper layers, 1.6 mm thick.
What parts does the ControlBoard use?
247 parts, built around the ATMEGA328P-PU, 74HC595, 25LC512-I/P and 74AHC04D. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the ControlBoard KiCad files?
From the andreaslagler/giove8k repository on GitHub, at the commit this page was made from: the board is hw/ControlBoard/ControlBoard.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Can I use the ControlBoard design in my own project?
Its repository publishes it under the GPL-3.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).