
Optiplower
jamwaffles/optiplower
Power a Dell Optiplex 3050 Micro from a 24V industrial power supply

Motor control schematic is an open-source printed circuit board by BujoreanuVlad, from the BujoreanuVlad/ChessRobotArm repository on GitHub. It is a 2-layer board with 12 parts on 52 nets.
It is built around the ARDUINO UNO R3, LM2596S-ADJ and XL4015E1. Its parts include 3 ICs, 1 resistor and 1 switch. It belongs with the robots and motor control boards and the AVR (ATmega, ATtiny) boards of this library.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 4 | Motor_Servo | Motors:Vybronics_VZ30C1T8219732L | BaseServo1, ClawServo1, ElbowServo1, WristServo1 |
| 2 | LM2596S-ADJ | Package_TO_SOT_SMD:TO-263-5_TabPin3 | U2, U3 |
| 1 | 10K | Resistor_THT:R_Axial_DIN0204_L3.6mm_D1.6mm_P7.62mm_Horizontal | R1 |
| 1 | Arduino_UNO_R3 | Module:Arduino_UNO_R3 | A1 |
| 1 | Pololu_Breakout_DRV8825 | Module:Pololu_Breakout-16_15.2x20.3mm | A2 |
| 1 | SW_Push | Button_Switch_THT:SW_XKB_DM1-16UP-1 | SW1 |
| 1 | Stepper_Motor_bipolar | Motors:Vybronics_VZ30C1T8219732L | ShoulderStepper1 |
| 1 | XL4015 | Package_TO_SOT_SMD:TO-263-5_TabPin3 | U1 |

jamwaffles/optiplower
Power a Dell Optiplex 3050 Micro from a 24V industrial power supply

GonzaCerv/noah-hardware
This repo contains all the hardware description for the Noah project. Here lies 3D models, electronics PCB and Firmware software of the robot.

SRA-VJTI/Evo-Borne
This repository focuses on building an open-source morphobot.

wenzel-lab/syringe-pumps-and-controller
Design of 3d printable syringe pumps and dual controller.



Digital-Naturalism-Laboratories/Mothbox_Electronics
This is where the electronics for the Mothbox are developed, such as the PCB! It's copied over from https://github.com/Digital-Naturalism-Laboratories/Mothbox/tree/main/Hardware/PCB so you can check that out if you want…

kwiecinski/MultiChem-Battery-Tester
Multi-chemistry (Lithum, PB and others) battery charger/discharger with capacitance measurement and discharge graph for diffrent charge/load currents.
12 parts, built around the ARDUINO UNO R3, LM2596S-ADJ and XL4015E1. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the BujoreanuVlad/ChessRobotArm repository on GitHub, at the commit this page was made from: the board is pcb_schematic/motor_control_schematic.kicad_pcb and its schematic pcb_schematic/motor_control_schematic.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask BujoreanuVlad before reusing the design.