
SuperPower RPi KiCAD
SensorsIot/SuperPower
Here you should find the best power supplies for your low-power projects
Thumb extension device for Helix
Thumbhelix is an open-source printed circuit board by yskoht, from the yskoht/thumbhelix-device repository on GitHub, published under the MIT licence. It is a 2-layer board of 25 × 48 mm with 13 parts on 9 nets, routed with 126 tracks and 22 vias.
It is built around the ATTINY85-20SU. Its parts include 2 connectors, 1 resistor, 1 IC and 1 switch. It belongs with the keyboards and input boards and the AVR (ATmega, ATtiny) boards of this library.
Thumbhelix device rev1 has some issues. If you are going to build it, it is not recommended. Please wait for rev2.
![]()
Thumbhelix is the thumb extension for Helix keyboard.
About Thumbhelix software, please see the following.
This software is released under the MIT License, see LICENSE.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 6 | HOLE_2mm | Hole:HOLE_2mm | H**, H**, H**, H**, H**, H** |
| 1 | 470 | Resistors_SMD:R_1206_HandSoldering | R2 |
| 1 | ATTINY85-20SU | Atmel:ATTINY85-20SUR | U1 |
| 1 | I2C | Conn:Conn_02x02 | P2 |
| 1 | ICSP | Conn:Conn_02x03 | P1 |
| 1 | JT8P-3.2T-B10K-1-16Y | Joystick:JT8P-3.2T-B10K-1-16Y | TS1 |
| 1 | Jumper | Conn:Conn_01x02 | JP1 |
| 1 | SW_Push | Keyswitch:KEYSWITCH | SW1 |

SensorsIot/SuperPower
Here you should find the best power supplies for your low-power projects

KivApple/dell-charger-emulator
Emulator of original Dell charger using ATTINY85


bwack/C64-Saver-bwack
C64 Saver v1 and v2 - Overvoltage protection for the C64 and its power brick.


valerionew/very-good-uc-doggos
A special graduation present for a special friend. Six microcontrollers in one devboard


spielhuus/LoRa-Environmental-Sensors
ATtiny85 based LoRa atmospheric sensor board with BME280
It measures 25 × 48 mm and has 2 copper layers, 1.6 mm thick.
13 parts, built around the ATTINY85-20SU. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the yskoht/thumbhelix-device repository on GitHub, at the commit this page was made from: the board is rev1/pcb/thumbhelix.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the MIT licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).