
FSR Breakout
team178/InnovationChallenge2021
Team 178's solution to the Innovation Challenge -- the god tier posture chair

Team 178's solution to the Innovation Challenge -- the god tier posture chair
FSR+Gyro Breakout is an open-source printed circuit board by team178, from the team178/InnovationChallenge2021 repository on GitHub. It is a 2-layer board of 39.4 × 17.8 mm with 10 parts on 12 nets, routed with 76 tracks and 0 vias.
It is built around the MPU-6050. Its parts include 4 capacitors, 3 resistors, 1 IC and 1 connector. It belongs with the interfaces and adapters boards of this library.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 3 | 0.1 uF | Capacitor_THT:C_Disc_D5.0mm_W2.5mm_P2.50mm | C1, C2, C3 |
| 2 | 2.2 kΩ | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P7.62mm_Horizontal | R1, R2 |
| 1 | 10 kΩ | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P7.62mm_Horizontal | R3 |
| 1 | 2200 pF | Capacitor_THT:CP_Radial_D5.0mm_P2.50mm | C4 |
| 1 | Conn_01x06_Male | Connector_PinHeader_2.00mm:PinHeader_1x06_P2.00mm_Horizontal | J1 |
| 1 | FSR | Connector_PinHeader_2.00mm:PinHeader_1x02_P2.00mm_Horizontal | RF1 |
| 1 | MPU-6050 | Sensor_Motion:InvenSense_QFN-24_4x4mm_P0.5mm | U1 |

team178/InnovationChallenge2021
Team 178's solution to the Innovation Challenge -- the god tier posture chair


ZhuYanzhen1/MM32_CLion
本项目是全国大学生智能车竞赛GDUT 2022年极速越野组的项目文件。采用了LQR控制器和多速率卡尔曼融合算法,并在单片机上实现。This project is the project document for the GDUT 2022 Extreme Off-Road Category of the National Student Intelligent Vehicle Competition.


victorhook/asac-fc
asac fc is an rp2040 based flight controller made for FPV drone flying




pms67/PModlet
PMOD PCB with USB-to-UART converter and IMU (MPU-6050, I2C) for FPGAs.
It measures 39.4 × 17.8 mm and has 2 copper layers, 1.6 mm thick.
10 parts, built around the MPU-6050. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the team178/InnovationChallenge2021 repository on GitHub, at the commit this page was made from: the board is Circuit design layout/current/FSR Breakout/FSR+Gyro Breakout/FSR+Gyro Breakout.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask team178 before reusing the design.