
Keep breathing ctrl
CV19CO/open_controller_for_ventilator
Open source controller for ventilators

Open source controller for ventilators
Electrovalves module is an open-source printed circuit board by CV19CO, from the CV19CO/open_controller_for_ventilator repository on GitHub. It is a 2-layer board of 45.6 × 25.3 mm with 8 parts on 6 nets, routed with 32 tracks and 0 vias.
It is built around the IRF540N. Its parts include 3 resistors, 3 connectors, 1 diode and 1 transistor.


| Qty | Value | Footprint | References |
|---|---|---|---|
| 2 | Conn_01x02_Male | TerminalBlock:TerminalBlock_bornier-2_P5.08mm | J1, J2 |
| 1 | 100 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P7.62mm_Horizontal | R3 |
| 1 | 1N4007 | Diode_THT:D_DO-41_SOD81_P10.16mm_Horizontal | D1 |
| 1 | 20k | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P7.62mm_Horizontal | R1 |
| 1 | 5.1k | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P7.62mm_Horizontal | R2 |
| 1 | Conn_01x02_Female | TerminalBlock:TerminalBlock_bornier-2_P5.08mm | J3 |
| 1 | IRF540N | Package_TO_SOT_THT:TO-220-3_Vertical | Q1 |

CV19CO/open_controller_for_ventilator
Open source controller for ventilators

CV19CO/open_controller_for_ventilator
Open source controller for ventilators

CV19CO/open_controller_for_ventilator
Open source controller for ventilators


CV19CO/open_controller_for_ventilator
Open source controller for ventilators

CV19CO/open_controller_for_ventilator
Open source controller for ventilators

CV19CO/open_controller_for_ventilator
Open source controller for ventilators

profdc9/DRSSTC-PCB-Pack
A pack of PCBs for a dual resonant solid state tesla coil setup. Pretty much everything you need.





AmericanRework/Pico-2x-BLDC
One RP2040 Pico drives two brushless motors! SimpleFOC + Halls + 2304 drivers + TO-220 mosfets or IGBTs. Plugs directly into 450x automower motors.

chgopireddy/Full-Bridge-Class-D-Audio-Amplifier
LTspice Model for Full Bridge Class D, Voltage Mode Control, Peak Current Mode Control

cnobile2012/Li-IonBatteryProtection
Circuit to protect Li-Ion and Li-Po batteries at the cell level.
It measures 45.6 × 25.3 mm and has 2 copper layers, 1.6 mm thick.
8 parts, built around the IRF540N. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the CV19CO/open_controller_for_ventilator repository on GitHub, at the commit this page was made from: the board is electrovalve_module/electrovalves_module.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask CV19CO before reusing the design.