
Relatively Universal ROM Programmer
AndersBNielsen/Relatively-Universal-ROM-Programmer
Hardware to program W27C512 EEPROM or any 24/28/32 pin ROM requiring from 5V to 27V programming voltage.

Submission of Devansh Verma (250331) for Electronics Club Secratory Reqruitement task
ElectronicDice is an open-source printed circuit board by Dev-ansh-V, from the Dev-ansh-V/PCB-Design--Electronic-Dice repository on GitHub. It is a 2-layer board of 119.5 × 115 mm with 21 parts on 37 nets, routed with 78 tracks and 0 vias.
It is built around the ARDUINO UNO R3. Its parts include 7 resistors, 7 diodes, 1 connector and 1 switch. It belongs with the AVR (ATmega, ATtiny) boards of this library.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 7 | 220 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P10.16mm_Horizontal | R1, R2, R3, R4, R5, R6, R7 |
| 7 | LED | LED_THT:LED_D5.0mm | D1, D2, D3, D4, D5, D6, D7 |
| 1 | Arduino_UNO_R3 | Module:Arduino_UNO_R3 | A1 |
| 1 | Conn_01x02_Pin | Connector_PinHeader_2.54mm:PinHeader_1x02_P2.54mm_Vertical | J1 |
| 1 | SW_Push | Button_Switch_THT:SW_PUSH_6mm | SW1 |
The 17 most common of 21 parts.

AndersBNielsen/Relatively-Universal-ROM-Programmer
Hardware to program W27C512 EEPROM or any 24/28/32 pin ROM requiring from 5V to 27V programming voltage.

AlanFord/self-balancing-stick
Dual Axis Reaction Wheel Inverted Pendulum

Edging-Machines/Edging-Machines
This repository is intended to contain as much information as possible about building, designing, prototyping, and using automated edging machines.

PedroCNeves/AC_ChargingStation
A learning project to create an EV AC Charging station based on an Arduino Uno

jonsag/arduTester
An arduino component tester based on https://create.arduino.cc/projecthub/plouc68000/ardutester-v1-13-the-arduino-uno-transistor-tester-dbafb4


ICRS/101
The all-new open source Robotics 101 course from ICRS. It's specifically designed to be run in hackspaces, after school clubs and university societies.

It measures 119.5 × 115 mm and has 2 copper layers, 1.6 mm thick.
21 parts, built around the ARDUINO UNO R3. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the Dev-ansh-V/PCB-Design--Electronic-Dice repository on GitHub, at the commit this page was made from: the board is ElectronicDice/ElectronicDice.kicad_pcb and its schematic ElectronicDice/ElectronicDice.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask Dev-ansh-V before reusing the design.