Skip to the content

TPS62827DMQR

Texas InstrumentsExtended

-40℃~+125℃@(TJ) 1 2.2MHz 2.5V~5.5V 4A 4uA 600mV~4V Adjustable Buck Buck Built-in Yes VSON-6(1.5x1.5) DC-DC Converters ROHS

Part id
ti/TPS62827DMQR
Category
DC DC Converters
Package
VSON-6(1.5x1.5)
Pins
6
In stock
464 at JLCPCB (C2071448)
Used on
3 open-source boards

Overview

The TPS62827DMQR is a DC DC Converter made by Texas Instruments in a VSON-6(1.5x1.5) package with 6 pins. -40℃~+125℃@(TJ) 1 2.2MHz 2.5V~5.5V 4A 4uA 600mV~4V Adjustable Buck Buck Built-in Yes VSON-6(1.5x1.5) DC-DC Converters ROHS.

PCBKit's library has its KiCad symbol (Celestial_Power_Switchmode:TI TPS62827DMQ, from Altium's library) and its footprint (EasyEDA_Cloud:VSON-6_L1.5-W1.5-P0.50-TL, from EasyEDA), ready for a KiCad board. 464 are in stock at JLCPCB (part C2071448). 3 open-source boards in 3 repositories on GitHub use it.

Symbol

6VIN1EN2PG5SW3FB4GND
Celestial_Power_Switchmode:TI TPS62827DMQFrom Altium's library

Footprint

EasyEDA_Cloud:VSON-6_L1.5-W1.5-P0.50-TLFrom EasyEDA

From the datasheet

13
Supply, least
2.5 V · VIN, recommended operating min · p. 4
Supply, most
5.5 V · VIN, recommended operating max · p. 4
Supply, absolute maximum
6 V · VIN, absolute max · p. 4
Junction, hottest
150 °C · Junction temperature absolute max · p. 4
Takes working
4 µA · VIN quiescent current typical, EN high, no load, device not switching · p. 5
Takes asleep
50 nA · Shutdown current typical, EN low, TJ = -40 ℃ to 85 ℃ · p. 5
Gives
4 A · Continuous output current max · p. 4
Current limit
5.6 A · High-side FET switch current limit, DC typical · p. 6
Feedback reference
600 mV · Feedback regulation voltage typical, PWM mode · p. 5
Switches at
2.2 MHz · PWM switching frequency typical, IOUT = 1 A, VOUT = 1.8 V · p. 6
Junction to air (TPS6282x, JEDEC)
129.5 K/W · Junction-to-ambient thermal resistance typical, JEDEC board · p. 4
Junction to case (TPS6282x, JEDEC)
103.9 K/W · Junction-to-case top thermal resistance typical · p. 4
Junction to board (TPS6282x, JEDEC)
33.1 K/W · Junction-to-board thermal resistance typical · p. 4

What it is and has

9
Control topology
DCS-Control · p. 1
Efficiency
Up to 97% · p. 1
Adjustable output voltage
0.6V to 4V · p. 1
Light-load operation
Power save mode · p. 1
Output discharge
Active · p. 1
Power-good output
Available · p. 1
Protection
Thermal shutdown · p. 1
Protection
Hiccup short-circuit protection · p. 1
Package
DMQ (VSON-HR, 6), 1.5mm × 1.5mm · p. 1

Around it

4
ind 0.47 µH
between SW and VOUT; L1 in the TPS62827 typical application; 1.8 V output. · p. 11
cap 4.7 µF
between VIN and GND; C1 in the TPS62827 typical application. · p. 11
cap 3x10 µF
between VOUT and GND; C2 output capacitor bank in the TPS62827 typical application. · p. 11
cap 120 pF
between VOUT and FB; C3 in parallel with the upper feedback resistor in the TPS62827 typical application. · p. 11

Specifications

46
ParameterConditionsAs printedPage
Voltage at PinsVIN, FB, EN, PGmin -0.3 · max 6 V4
Voltage at PinsSW (DC) (4); maximum VIN + 0.3 Vmin -0.3 V4
Voltage at PinsSW (DC, in current limit); maximum VIN + 0.3 Vmin -1 V4
Voltage at PinsSW (AC, less than 10ns) (3)min -2.5 · max 10 V4
Voltage at PinsSW (AC, PFM Mode, less than 100ns) (3); maximum VIN + 1.0 Vmin -1 V4
Operating junction temperature TJmin -40 · max 150 °C4
Storage temperature Tstgmin -65 · max 150 °C4
Electrostatic discharge V(ESD)Human-body model (HBM), per ANSI/ESDA/JEDEC JS-001 (1); rated ±2000 Vmax 2000 V4
Electrostatic discharge V(ESD)Charged-device model (CDM), per JEDEC specification JESD22-C101 (2); rated ±500 Vmax 500 V4
Input voltage range, TPS62827x VINTPS62827xmin 2.5 · max 5.5 V4
Output voltage range VOUTmin 0.6 · max 4 V4
Output current range, TPS62827x IOUTTPS62827xmin 0 · max 4 A4
Sink current at PG pin ISINK_PGmax 1 mA4
Pull-up resistor voltage VPGmax 5.5 V4
Operating junction temperature TJmin -40 · max 125 °C4
Junction-to-ambient thermal resistance RθJATPS6282x, JEDEC, 6 pinstyp 129.5 °C/W4
Junction-to-case (top) thermal resistance RθJC(top)TPS6282x, JEDEC, 6 pinstyp 103.9 °C/W4
Junction-to-board thermal resistance RθJBTPS6282x, JEDEC, 6 pinstyp 33.1 °C/W4
Junction-to-top characterization parameter ψJTTPS6282x, JEDEC, 6 pinstyp 3.8 °C/W4
Junction-to-board characterization parameter ψJBTPS6282x, JEDEC, 6 pinstyp 33.1 °C/W5
Quiescent current IQEN = High, no load, device not switchingtyp 4 · max 10 uA5
Shutdown current ISDEN = Low, TJ = -40 ℃ to 85 ℃typ 0.05 · max 0.5 uA5
Under voltage lock out threshold VUVLOVIN fallingmin 2.1 · typ 2.2 · max 2.3 V5
Under voltage lock out hysteresis VUVLOVIN risingtyp 160 mV5
Thermal shutdown threshold TJSDTJ risingtyp 150 °C5
Thermal shutdown hysteresis TJSDTJ fallingtyp 20 °C5
High-level threshold voltage VIHmin 1 V5
Low-level threshold voltage VILmax 0.4 V5
Input leakage current into EN pin IEN,LKGEN = Hightyp 0.01 · max 0.1 uA5
Soft start time tSSTime from EN high to 95% of VOUT nominal, TPS62827typ 1.75 ms5
Power good lower threshold VPGVPG rising, VFB referenced to VFB nominalmin 94 · typ 96 · max 98 %5
Power good lower threshold VPGVPG falling, VFB referenced to VFB nominalmin 90 · typ 92 · max 94 %5
Power good upper threshold VPGVPG rising, VFB referenced to VFB nominalmin 108 · typ 110 · max 112 %5
Power good upper threshold VPGVPG falling, VFB referenced to VFB nominalmin 103 · typ 105 · max 107 %5
Low-level output voltage VPG,OLIsink = 1 mAmax 0.4 V5
Input leakage current into PG pin IPG,LKGVPG = 5.0 Vtyp 0.01 · max 0.1 uA5
Power good deglitch delay tPG,DLYPG rising edgetyp 100 us5
Power good deglitch delay tPG,DLYPG falling edgetyp 20 us5
Feedback regulation voltage VFBPWM modemin 594 · typ 600 · max 606 mV5
Feedback input leakage current for adjustable output voltage IFB,LKGVFB = 0.6 Vtyp 0.01 · max 0.05 uA5
Output discharge current IDISVSW = 0.4V; EN = LOWmin 75 · typ 400 mA5
Load regulationIOUT = 0.5 A to 3 A, VOUT = 1.8 Vtyp 0.1 %/A5
High-side FET on-resistance RDS(on)typ 26 mΩ5
Low-side FET on-resistance RDS(on)typ 25 mΩ5
High-side FET switch current limit, DC ILIMTPS62827xmin 4.8 · typ 5.6 · max 6.4 A6
PWM switching frequency fSWIOUT = 1 A, VOUT = 1.8 Vtyp 2.2 MHz6

Pins, by the datasheet

6
1 EN
Device enable: pull high to enable or low to disable; do not leave floating. · p. 3
2 PG
Power-good output; pullup may connect to voltages up to 5.5V; leave floating if unused. · p. 3
3 FB
Feedback pin; fixed output voltage versions connect this pin to the output. · p. 3
4 GND
Ground pin. · p. 3
5 SW
Switch pin of the power stage. · p. 3
6 VIN
Input voltage pin. · p. 3

Open-source boards using it

3
  • 4 layers145.5 × 64 mmMuffin, the printed circuit board in 3D

    Muffin

    JunOllyLi/TX_PCB

    NOTE: the latest PCB had been manufactured was v2.0. But it had the Gimbal ZH-connector reversed. The schematics and PCB drawing had been updated to v2.1 to fix that. But v2.1 had not been really manufactured yet.

    138 parts17
  • 6 layers70 × 80 mmCm5-carrier v2, the printed circuit board in 3D

    Cm5-carrier v2

    ben5049/cm-carrier-hardware

    Compact CM5 carrier board with an M.2 E-key connector and a 1000BASE-T1 Ethernet PHY, as well as other optional IO.

    334 parts1AGPL-3.0
  • 4 layers82 × 34 mmKatanori61 audio, the printed circuit board in 3D

    Katanori61 audio

    n416/katanori

    ⚠ 2026-09-15 に全体を書き直した(2026-08-19 の状態のまま止まっていて、「筐体 v2 を設計中」「電池はまだ」と書いてあった)。

    185 parts

Parts like it

1

Questions

Is there a KiCad symbol and footprint for the TPS62827DMQR?

Yes. The symbol is Celestial_Power_Switchmode:TI TPS62827DMQ and the footprint EasyEDA_Cloud:VSON-6_L1.5-W1.5-P0.50-TL, both drawn on this page. PCBKit places them on a board for you when you design with it.

What package is the TPS62827DMQR?

VSON-6(1.5x1.5), with 6 pins. Its footprint is drawn on this page.

Where is the TPS62827DMQR datasheet?

Texas Instruments publishes it: the Datasheet link on this page opens it.

Where can I order the TPS62827DMQR?

JLCPCB lists it as part C2071448, with 464 in stock; the sellers' links on this page open their listings.

What can replace the TPS62827DMQR?

Parts like it in the library: the TPS62827DMQT by Texas Instruments. Check their datasheets: a part that fits the footprint may still differ in its ratings.

Which open-source boards use the TPS62827DMQR?

3 boards in 3 repositories on GitHub; the most starred are listed on this page, with their KiCad files.