ME4055AM6G-N
MICRONEExtended
-40℃~+85℃ 1 4.2V 4V~9V 55uA 800mA Charging IC Support SOT-23-6 Battery Management ROHS
- Part id
- microne/ME4055AM6G-N
- Category
- Battery Management
- Package
- SOT-23-6
- Pins
- 6
- In stock
- 425 at JLCPCB (C82121)
Overview
The ME4055AM6G-N is a battery Management made by MICRONE in a SOT-23-6 package with 6 pins. -40℃~+85℃ 1 4.2V 4V~9V 55uA 800mA Charging IC Support SOT-23-6 Battery Management ROHS.
PCBKit's library has its KiCad symbol (EasyEDA_Pro:ME4055AM6G-N, from EasyEDA Pro) and its footprint (Package_TO_SOT_SMD:SOT-23-6, from KiCad's library), ready for a KiCad board. 425 are in stock at JLCPCB (part C82121).
Symbol
The library has no symbol for this part yet.
Footprint
The library has no footprint for this part yet.
From the datasheet
11- Supply, least
- 4 V · VCC, recommended operating min · p. 5
- Supply, most
- 9 V · VCC, operating max; restricted charging current · p. 5
- Supply, absolute maximum
- 10 V · VCC, absolute max · p. 4
- Works from
- -40 °C · Operating ambient min · p. 4
- Works up to
- 85 °C · Operating ambient max · p. 4
- Junction, hottest
- 150 °C · Junction temperature absolute max · p. 4
- Takes working
- 150 µA · VCC quiescent current typical, charging, RPROG=2.2KΩ · p. 5
- Takes asleep
- 55 µA · VCC standby current typical, charging completed · p. 5
- Gives
- 800 mA · Charging current max; input recommended at most 5.5V · p. 5
- Output
- 4.2 V · Fixed float voltage typical, ME4055AM6G-N · p. 2
- Junction to air (SOT23-6)
- 200 K/W · Junction to ambient · p. 4
What it is and has
9- Charging method
- Constant current and constant voltage · p. 1
- Programmable charging current
- Up to 800mA · p. 1
- Protection
- Reverse battery protection · p. 1
- Protection
- Internal thermal feedback · p. 1
- Automatic recharge
- Supported · p. 1
- Charge termination
- C/10 · p. 1
- Status outputs
- Two charging status outputs, with no-battery and fault indication · p. 1
- Soft start
- Limits inrush current · p. 1
- Package
- 6-pin SOT23-6 · p. 1
Around it
2- res 10k
- between PROG and CFILTER; Series isolation resistor for the optional average charging current monitoring filter. · p. 8
- res 1.5Ω
- between VCC and X5R bypass capacitor; Optional resistor in series with the X5R ceramic bypass capacitor to reduce startup voltage transients. · p. 10
Specifications
40| Parameter | Conditions | As printed | Page |
|---|---|---|---|
| 输入电压 VCC | min -0.3 · max 10 V | 4 | |
| PROG 引脚电压 | Upper limit VCC+0.3 V | min -0.3 V | 4 |
| BAT 引脚电压 | min -0.3 · max 10 V | 4 | |
| STDBY引脚电压 | min -0.3 · max 10 V | 4 | |
| CHRG引脚电压 | min -0.3 · max 10 V | 4 | |
| BAT 引脚电流 | max 800 mA | 4 | |
| PROG 引脚电流 | max 1200 uA | 4 | |
| 结温范围 | min -40 · max 150 ℃ | 4 | |
| 工作环境温度范围 Topa | min -40 · max 85 ℃ | 4 | |
| 存储温度范围 Tstr | min -55 · max 150 ℃ | 4 | |
| 引脚温度和时间 | 10S | max 260 ℃ | 4 |
| 封装热阻(结到空气) | SOT23-6 | typ 200 ℃/W | 4 |
| 封装功耗 | SOT23-6 | max 0.63 W | 4 |
| 输入电压 VCC | Entire operating temperature range; see input-voltage limitation note | min 4 · typ 5 · max 9 V | 5 |
| 静态电流 ICC -IBAT | 充电模式, RPROG=2.2KΩ; entire operating temperature range | typ 150 · max 500 uA | 5 |
| 静态电流 ICC -IBAT | 待机模式(充电结束); entire operating temperature range | typ 55 · max 100 uA | 5 |
| 静态电流 ICC -IBAT | 关断模式(RPROG 不接, VCC<VBAT, or VCC<VUV); entire operating temperature range | typ 55 · max 100 uA | 5 |
| 充电截止电压 VFLOAL | ME4055A-N; 0℃≤TA≤85℃ | min 4.158 · typ 4.2 · max 4.242 V | 5 |
| 充电电流(电流模式 VBAT=3.9V) IBAT | RPROG=2.2KΩ,电流模式; entire operating temperature range | min 490 · typ 580 · max 670 mA | 5 |
| 充电电流(电流模式 VBAT=3.9V) IBAT | 待机模式; VBAT=4.2V for ME4055A-N; entire operating temperature range | min -6 · typ -2.5 · max 0 uA | 5 |
| 充电电流(电流模式 VBAT=3.9V) IBAT | RPROG 悬空; magnitudes printed as ±1 and ±2 | typ 1 · max 2 uA | 5 |
| 充电电流(电流模式 VBAT=3.9V) IBAT | 睡眠模式,VCC=0V | typ -1 · max -2 uA | 5 |
| 涓流充电电流 ITRIKL | VBAT<VTRIKL, RPROG=2.2KΩ; entire operating temperature range | min 46 · typ 73 · max 163 mA | 5 |
| 涓流切换阈值 VTRIKL | RPROG=2.2KΩ, VBAT 上升 | min 2.7 · typ 2.85 · max 3 V | 5 |
| 涓流切换阈值迟滞 VTRHYS | RPROG=2.2KΩ | min 350 · typ 400 · max 450 mV | 5 |
| VCC 欠压锁定 VUV | VCC 由低到高; entire operating temperature range | min 3.5 · typ 3.7 · max 3.9 V | 5 |
| VCC 欠压锁定迟滞 VUVHYS | Entire operating temperature range | min 150 · typ 200 · max 300 mV | 5 |
| VCC-VBAT 锁定阈值电压 VASD | VCC 由低到高 | min 100 · typ 140 · max 180 mV | 5 |
| VCC-VBAT 锁定阈值电压 VASD | VCC 由高到低 | min 50 · typ 80 · max 110 mV | 5 |
| C/10 充电终止电流 ITERM | RPROG=2.2KΩ; entire operating temperature range | min 60 · typ 70 · max 80 mA | 5 |
| PROG 引脚电压 VPROG | RPROG=2.2KΩ,电流模式; entire operating temperature range | min 0.9 · typ 1 · max 1.1 V | 5 |
| CHRG 引脚输出低电压 VCHRG | ICHRG=5mA | typ 0.3 · max 0.6 V | 5 |
| STDBY引脚输出低电压 VSTDBY | ISTDBY=5mA | typ 0.3 · max 0.6 V | 5 |
| 再充电阈值 ΔVRECHRG | VFLOAT -VRECHRG | min 60 · typ 150 · max 240 mV | 5 |
| 温度保护阈值 TLIM | typ 145 ℃ | 5 | |
| P-MOSFET 导通电阻 RON | typ 650 mΩ | 5 | |
| 软启动时间 tSS | IBAT=0 to IBAT=1270V/RPROG | typ 20 uS | 5 |
| 再充电延迟时间 tRECHARGE | VBAT 由低到高 | min 0.8 · typ 1.8 · max 4 mS | 5 |
| 充电截止延迟时间 tTERM | IBAT below ICHG/10 | min 0.8 · typ 1.8 · max 4 mS | 5 |
| PROG 引脚上拉电流 IPROG | typ 2 uA | 5 |
Pins, by the datasheet
6- 1 CHRG
- Charging status output; pulls low while charging and is high impedance otherwise. · p. 3
- 2 GND
- Ground. · p. 3
- 3 BAT
- Battery connection and charging output. · p. 3
- 4 VCC
- Input supply; enters sleep when the input approaches the battery voltage within 80mV. · p. 3
- 5 STDBY
- Charge completion output; pulls low when charging terminates and is high impedance otherwise. · p. 3
- 6 PROG
- Charging current programming and monitoring; connect a programming resistor to ground. · p. 3
Ordering codes, by the datasheet
2- ME4055AM6G-N
- SOT23-6 · 4.2V float voltage · p. 2
- ME4055DM6G-N
- SOT23-6 · 4.34V float voltage · p. 2
Parts like it
8TP4057
SOT-23-6-40℃~+85℃ 1 25uA 4.24V 4V~6.5V 500mA Charging IC Lithium Battery Support 恒流充电、恒压充电、涓流充电、自动再充电、充电终止、可编程充电电流、软启动、欠压锁定 SOT-23-6 Battery Management ROHSUMWBattery ManagementDW01A
SOT-23-6L-40℃~+85℃ 1 2.5V 300mV~10V 3uA 4.3V Protection IC Support SOT-23-6L Battery Management ROHSPUOLOPBattery ManagementDW01-A/J
SOT-23-6-40℃~+85℃ 1 1.5V~10V 2.5V 4.3V 700nA Lithium Battery Protection IC Support SOT-23-6 Battery Management ROHSShenzhen Fuman ElecBattery ManagementTP4057-42-SOT26-R
SOT-23-6-40℃~+85℃ 1 4.2V 40uA 4V~9V 500mA Charging IC Lithium Battery Not supported Not supported SOT-23-6 Battery Management ROHSTOPPOWERBattery ManagementDW01A
SOT-23-6-40℃~+85℃ 1 1.5V~8V 2.4V 4.3V 4uA Not supported Protection IC Support SOT-23-6 Battery Management ROHSYONGYUTAIBattery ManagementHY2120-CB
SOT-23-6-40℃~+85℃ 1.5V~10V 100nA 2 2.9V 4.28V Protection IC Support SOT-23-6 Battery Management ROHSHYCON TechBattery ManagementDW01
SOT-23-6-40℃~+85℃ 1 1.5V~8V 2.4V 4.3V 4uA Lithium Battery Not supported Overcharge protection、Over-discharge protection、Overcurrent Protection、Short-Circuit Protection Protection IC Support SOT-23-6 Battery Management ROHSGuangdong HottechBattery ManagementHY2213-BB3A
SOT-23-6-40℃~+85℃ 1 1.5V~8V 2uA 4.19V Balancing IC Lithium Battery Not supported SOT-23-6 Battery Management ROHSHYCON TechBattery Management
Questions
Is there a KiCad symbol and footprint for the ME4055AM6G-N?
Yes. The symbol is EasyEDA_Pro:ME4055AM6G-N and the footprint Package_TO_SOT_SMD:SOT-23-6, both drawn on this page. PCBKit places them on a board for you when you design with it.
What package is the ME4055AM6G-N?
SOT-23-6, with 6 pins. Its footprint is drawn on this page.
Where is the ME4055AM6G-N datasheet?
MICRONE publishes it: the Datasheet link on this page opens it.
Where can I order the ME4055AM6G-N?
JLCPCB lists it as part C82121, with 425 in stock; the sellers' links on this page open their listings.
What can replace the ME4055AM6G-N?
Parts like it in the library: the TP4057 by UMW, the DW01A by PUOLOP, the DW01-A/J by Shenzhen Fuman Elec and the TP4057-42-SOT26-R by TOPPOWER. Check their datasheets: a part that fits the footprint may still differ in its ratings.