Pihat cooling is an open-source printed circuit board by vanbwodonk, from the vanbwodonk/pihat-cooling repository on GitHub, published under the GPL-2.0 licence. It is a 2-layer board of 65 × 56 mm with 47 parts on 49 nets, routed with 191 tracks and 41 vias.
It is built around the LM2596S-5.0, AO3401A and MMBT3904, with the MMBT3906 among its other parts. Its parts include 12 resistors, 9 diodes, 4 transistors, 3 capacitors and 3 connectors. It belongs with the power boards of this library.
Raspberry Pi Hat with fan controller and external power supply. Raspberry pi need 5 Volt 15 watt power supply, this Pi Hat can replace it with 9/12 Volt power supply 18 watt or more. PCB is design with KiCad 5.1.
Features
Wide range DC power input up to 40 Volt (or battery for my application).
Fan controller with switchable 5 volt or direct DC in supply. Change J2 jumper close to pi header for 5 Volt fan supply or jumper close to button for direct DC supply. Usually pi fan is for 5 Volt, but i try 5 volt fan with 12 volt battery is no problem at all.
Overheat indicator with led (1 led programmable).
Over voltage + Reverse protection.
You can replace all components. Just a little note for Q1 and Q3 (P-Channel Mosfet) drain current is 3 Ampere or more.
2 programmable button (i used it for shutdown & reboot).
Installation
Download python scripts from:
bash
pip3 install RPi.GPIO
mkdir scripts
cd scripts
wget https://raw.githubusercontent.com/vanbwodonk/pihat-cooling/master/Firmware/Python/main.py
Running:
bash
sudo python3 /home/pi/scripts/main.py
Donation
If this project help you, you can give me a cup of coffee :)
It measures 65 × 56 mm and has 2 copper layers, 1.6 mm thick.
What parts does the Pihat cooling use?
47 parts, built around the LM2596S-5.0, AO3401A, MMBT3904 and MMBT3906. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the Pihat cooling KiCad files?
From the vanbwodonk/pihat-cooling repository on GitHub, at the commit this page was made from: the board is PCB/pihat_cooling.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Can I use the Pihat cooling design in my own project?
Its repository publishes it under the GPL-2.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).