GNSS LED Matrix Clock Hardware
This repository contains KiCad hardware designs for a GNSS-oriented clock and LED matrix display. The primary design combines an STM32C0-series controller with an ATGM336H GNSS receiver; separate files capture a CH32V003-based 5x7 display design.
Designs
Main clock controller
The root KiCad project (clk_led_matrix) contains the main schematic, PCB layout, and an STM32CubeMX configuration. The schematic includes:
- An STM32C0-series MCU and ATGM336H-5N31 GNSS module.
- GNSS UART and I2C signal connections, plus USB 2.0 over a USB-C receptacle.
- Power circuitry, a reset switch, and a 2x3 debug/programming header.
- A four-layer PCB layout.
The .ioc file configures RTC, USB device, two I2C peripherals, and two UART peripherals. It is MCU configuration metadata, not firmware source code.
CH32 LED display design
The ch32_led/ directory contains a separate two-layer KiCad project built around a CH32V003 and a Lite-On LTP-305G green 5x7 dot-matrix display. Its schematic also includes a three-position DIP switch, address-selection signals, and a six-pin connector.
5x7_MCU_Block.kicad_sch is a standalone schematic for the CH32V003/display circuit, useful as a reference or reusable block. It is not a hierarchical sheet currently included in the root schematic.
Repository contents
| Path | Description |
|---|
clk_led_matrix.kicad_pro | Main KiCad project settings |
clk_led_matrix.kicad_sch | Main clock-controller schematic |
clk_led_matrix.kicad_pcb | Main four-layer PCB layout |
clk_led_matrix.ioc | STM32CubeMX configuration for the main MCU |
ch32_led/ | Separate CH32V003 5x7 display schematic and PCB project |
5x7_MCU_Block.kicad_sch | Standalone CH32V003 and 5x7 display schematic block |
fp-lib-table | KiCad footprint library table |
Opening the designs
Open clk_led_matrix.kicad_pro in KiCad to work on the main design. Open ch32_led/ch32_led.kicad_pro for the CH32 display board. The design files use KiCad 10-era file formats; older KiCad versions may not open them correctly.
The repository currently contains hardware design files, not embedded application source, generated firmware, a bill of materials, or fabrication exports. No firmware build or flashing procedure is defined here.
Design note
Before ordering parts for the main controller, verify the exact STM32 package: the schematic symbol is named STM32C071KBUx, while clk_led_matrix.ioc identifies STM32C071KBT6. Confirm that the schematic, footprint, PCB, and MCU configuration all target the intended orderable part.