4 layers78 × 78 mm
2 layers100 × 100 mm
Inteldon v1
igori5/inteldon_v1- Size
- 100 × 100 mm
- Copper layers
- 2
- Thickness
- 1.6 mm
- Parts
- 237
- Nets
- 165
- Pads
- 761
- Tracks, vias
- 1,107, 609
- Pours
- 31
- Routed
- Yes
- KiCad
- KiCad 8.0 (file 20240108)
- Created
- 16 May 2025
- Updated
- 2 Jun 2025
Overview
Inteldon v1 is an open-source printed circuit board by igori5, from the igori5/inteldon_v1 repository on GitHub. It is a 2-layer board of 100 × 100 mm with 237 parts on 165 nets, routed with 1,107 tracks and 609 vias.
It is built around the UCC21330AD, L7812 and MIC5504-3.3YM5, with the 1N4148W, NTMFS5C628NL and BC817 among its other parts. Its parts include 84 resistors, 51 capacitors, 48 diodes, 24 transistors and 12 ICs. It belongs with the STM32 boards of this library.
Main components
7
UCC21330AD
SOIC-16SOIC-16 Isolators - Gate Drivers ROHSTexas InstrumentsIsolators - Gate Drivers
L7812
TO-220ST0℃~+125℃@(Tj) 1 1.2A 12V 2V@(1A) 30V 71dB@(120Hz) 76uV Fixed Positive Short Circuit Protection TO-220ST Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSOSENVoltage Regulators - Linear, Low Drop Out (LDO) Regulators
MIC5504-3.3YM5
SOT-23-5-40℃~+125℃@(Tj) 1 120uVrms 15uA 180mV@(300mA) 3.3V 300mA 5.5V 75dB@(1kHz) Fixed Over Temperature Protection、Enable Positive SOT-23-5 Voltage Regulators - Linear, Low Drop Out (LDO) Regulators ROHSTECH PUBLICVoltage Regulators - Linear, Low Drop Out (LDO) Regulators
1N4148W
SOD-123150mA 1A 1V@50mA 1uA@75V 400mW 4ns 75V Independent SOD-123 Switching Diodes ROHSSTMicroelectronicsSwitching Diodes
NTMFS5C628NL
SO-8FL-55℃~+175℃ 1 N-channel 1.7nF 110W 150A 28pF 2V 3.3mΩ@4.5V 3.6nF 52nC@10V 60V N-Channel SO-8FL MOSFETs ROHSonsemiMOSFETs
BC817
SOT-231 NPN 100nA 150MHz 300mW 40 45V 500mA 5V 700mV NPN SOT-23 Bipolar (BJT) ROHSShikuesBipolar (BJT)
WS2812B-2020
SMD,2.2x2mm0.6mA 0.84mm 120us 160mcd 200mcd 2kHz 2mm 2mm 300ns 470.4nm 515.6nm 520mcd 5V 622.5nm 800Kbit/s Built-in power-on reset circuit、Built-in power-on reset circuit、Integrated intelligent reverse connection protection function Top-mount SMD,2.2x2mm RGB LEDs(Built-in IC) ROHSWorldsemiRGB LEDs(Built-In IC)
README
README.md強めの4chDCモタドラ
出力電流：かなり
電源電圧：30Vまで
制御側電源：5V
インターフェース：CAN
欠陥1：ハイサイド側の放熱が弱い
欠陥2：デバッグ用UARTが逆
Parts
237| Qty | Value | Footprint | References |
|---|---|---|---|
| 32 | 10 | Resistor_SMD:R_0603_1608Metric | R207, R208, R209, R210, R211, R212, R213, R214, R307, R308, R309, R310, R311, R312, R313, R314 +16 |
| 31 | 10k | Resistor_SMD:R_0603_1608Metric | R101, R102, R103, R104, R105, R106, R107, R203, R204, R215, R216, R217, R218, R303, R304, R315 +15 |
| 25 | 0.1u | Capacitor_SMD:C_0603_1608Metric | C104, C106, C107, C108, C109, C110, C111, C112, C113, C201, C202, C203, C204, C301, C302, C303 +9 |
| 24 | 1N4148W | Diode_SMD:D_SOD-123 | D201, D202, D203, D204, D205, D206, D301, D302, D303, D304, D305, D306, D401, D402, D403, D404 +8 |
| 16 | 10u | Capacitor_SMD:C_0805_2012Metric | C205, C206, C207, C208, C305, C306, C307, C308, C405, C406, C407, C408, C505, C506, C507, C508 |
| 16 | MS18F | Diode_SMD:D_SOD-128 | D207, D208, D209, D210, D307, D308, D309, D310, D407, D408, D409, D410, D507, D508, D509, D510 |
| 16 | NTMFS5C628NL | Package_SO:ONSemi_SO-8FL_488AA | Q203, Q204, Q205, Q206, Q303, Q304, Q305, Q306, Q403, Q404, Q405, Q406, Q503, Q504, Q505, Q506 |
| 8 | 1k | Resistor_SMD:R_0603_1608Metric | R201, R202, R301, R302, R401, R402, R501, R502 |
| 8 | 20k | Resistor_SMD:R_0603_1608Metric | R205, R206, R305, R306, R405, R406, R505, R506 |
| 8 | BC817 | Package_TO_SOT_SMD:SOT-23 | Q201, Q202, Q301, Q302, Q401, Q402, Q501, Q502 |
| 8 | UCC21330 | Package_SO:SOIC-16_3.9x9.9mm_P1.27mm | U201, U202, U301, U302, U401, U402, U501, U502 |
| 4 | 100u | Capacitor_SMD:CP_Elec_10x10.5 | C209, C309, C409, C509 |
| 4 | LED | LED_SMD:LED_0603_1608Metric | D105, D106, D107, D108 |
| 4 | R | Resistor_SMD:R_0603_1608Metric | R108, R109, R110, R111 |
| 4 | WS2812B-2020 | LED_SMD:LED_WS2812B-2020_PLCC4_2.0x2.0mm | D101, D102, D103, D104 |
| 4 | XT30 | Connector_AMASS:AMASS_XT30PW-F_1x02_P2.50mm_Horizontal | J201, J301, J401, J501 |
| 2 | 10u | Capacitor_SMD:CP_Elec_6.3x5.9 | C114, C115 |
| 2 | 1u | Capacitor_SMD:C_0603_1608Metric | C103, C105 |
| 2 | 22p | Capacitor_SMD:C_0603_1608Metric | C101, C102 |
| 2 | Conn_01x04_Socket | Connector_JST:JST_XA_S04B-XASK-1_1x04_P2.50mm_Horizontal | J104, J105 |
| 1 | 120 | Resistor_SMD:R_0603_1608Metric | R112 |
| 1 | 16MHz | Crystal:Crystal_SMD_HC49-SD | Y101 |
| 1 | ATA6561 | Package_SO:SOIC-8_3.9x4.9mm_P1.27mm | U104 |
| 1 | Conn_01x02_Pin | Connector_AMASS:AMASS_XT60PW-M_1x02_P7.20mm_Horizontal | J102 |
| 1 | Conn_01x02_Socket | Connector_AMASS:AMASS_XT60PW-F_1x02_P7.20mm_Horizontal | J103 |
| 1 | Conn_02x07_Odd_Even | Connector_PinHeader_1.27mm:PinHeader_2x07_P1.27mm_Vertical_SMD | J101 |
| 1 | FerriteBead | Inductor_SMD:L_0603_1608Metric | FB101 |
| 1 | L7812 | Package_TO_SOT_SMD:TO-252-2 | U103 |
| 1 | MIC5504-3.3YM5 | Package_TO_SOT_SMD:SOT-23-5 | U101 |
| 1 | STM32F303K8Tx | Package_QFP:LQFP-32_7x7mm_P0.8mm | U102 |
| 1 | SW_DIP_x04 | Package_SO:SO-8_5.3x6.2mm_P1.27mm | SW101 |
| 1 | SW_Push | Button_Switch_THT:SW_PUSH_6mm | SW103 |
| 1 | SW_SPDT | Button_Switch_THT:SW_Slide-03_Wuerth-WS-SLTV_10x2.5x6.4_P2.54mm | SW102 |
The 233 most common of 237 parts.
Questions
How big is the Inteldon v1 PCB?
It measures 100 × 100 mm and has 2 copper layers, 1.6 mm thick.
What parts does the Inteldon v1 use?
237 parts, built around the UCC21330AD, L7812, MIC5504-3.3YM5 and 1N4148W. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the Inteldon v1 KiCad files?
From the igori5/inteldon_v1 repository on GitHub, at the commit this page was made from: the board is inteldon_v1.kicad_pcb and its schematic Hbridge.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Can I use the Inteldon v1 design in my own project?
Its repository states no licence, so its author keeps all rights: ask igori5 before reusing the design.
Similar boards
- 2 layers107.5 × 120 mm
Load
joaomariolago/ifsc-pi3-eletronic-load
Simple eletronic load with WiFi integration and preprogramed operation curves
135 partsApache-2.0 - 2 layers99.5 × 99.5 mm
ESP32 master
kwiecinski/BMS-and-offgrid-photovoltaic-management-system
Project contains BMS for lead-acid batteries and ESP-based board used to pull information from EASUN offgrid inverter, energy meters and sensors.
155 parts3MIT - 2 layers127.3 × 82.2 mm
Little red rover
little-red-rover/lrr-hardware
Hardware design files for Little Red Rover.
65 parts1CERN-OHL-W-2.0 - 4 layers23 × 31.3 mm
Temperature node
cegea/temperature_node_hw
PCB design for a temperature sensor based on SHT and ESP32
36 partsGPL-3.0 - 2 layers100 × 70 mm
- 4 layers100 × 90 mm
- 2 layers
