
UGC OpenMain
HandHeldLegend/Open-GC-Ultimate
Fully open, bare-bones GC Ultimate PCB made for makers and indies.

Fully open, bare-bones GC Ultimate PCB made for makers and indies.
UGC Trigger is an open-source printed circuit board by HandHeldLegend, from the HandHeldLegend/Open-GC-Ultimate repository on GitHub, published under the AGPL-3.0 licence. It is a 2-layer board of 9.3 × 19.1 mm with 3 parts on 2 nets, routed with 9 tracks and 0 vias.
Its parts include 2 connectors and 1 switch.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 2 | Conn_01x01_Pin | Connector_PinHeader_2.00mm:PinHeader_1x01_P2.00mm_Vertical | J1, J2 |
| 1 | SW_Push | hhl:starprint | SW1 |

HandHeldLegend/Open-GC-Ultimate
Fully open, bare-bones GC Ultimate PCB made for makers and indies.

HandHeldLegend/Open-GC-Ultimate
Fully open, bare-bones GC Ultimate PCB made for makers and indies.

HandHeldLegend/Open-GC-Ultimate
Fully open, bare-bones GC Ultimate PCB made for makers and indies.


hzeller/rpi-rgb-led-matrix
Controlling up to three chains of 64x64, 32x32, 16x32 or similar RGB LED displays using Raspberry Pi GPIO


atopile/atopile
Design circuit boards with code! ✨ Get software-like design reuse 🚀, validation, version control and collaboration in hardware; starting with electronics ⚡️




hackclub/sprig
🍃 Learn to code by making games in a JavaScript web-based game editor.
It measures 9.3 × 19.1 mm and has 2 copper layers, 1.6 mm thick.
3 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the HandHeldLegend/Open-GC-Ultimate repository on GitHub, at the commit this page was made from: the board is HW/Trigger/UGC_Trigger.kicad_pcb and its schematic HW/Main/UGC_OpenMain.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the AGPL-3.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).