
Iaq device
nkitanov/iaq_board
IAQ Board is a DIY (Do-It-Yourself) device for measuring internal air quality

Repoitory enthält Schaltplan, PCB, Software, Gehäusedsign
ETA Serial2MQTTGateway is an open-source printed circuit board by ene9ba, from the ene9ba/IoT-ETA-Gateway repository on GitHub, published under the MIT licence. It is a 2-layer board of 45.7 × 43.2 mm with 2 parts on 16 nets, routed with 32 tracks and 0 vias.
It is built around the WEMOS D1 MINI. Its parts include 1 IC and 1 connector. It belongs with the ESP8266 boards of this library.
Das Gehäuse wird über einen im Gehäuse integrierten Magneten einfach am Heizkessel befestigt
Der RS232-Konverter auf TTL wurde im Internet als IoT-Komponente zugekauft. Das Gateway benötigt noch eine 5 V Versorgung, die auch über den Seriellen Stecker D-Sub angebunden ist. Der IoT-Kern ist ein ESP8266 WEMOS D1

Prototyp:

Das Gateway startet die Kommunikation mit dem Ofen über ein Startprotokoll, wartet dann auf die zyklisch gemeldeten Daten, die dann checksummengeprüft über MQTT an openHAB übertragen werden. Die Visualisierung erfolgt mit Grafana.
Repoitory enthält Schaltplan, PCB, Software, Gehäusedsign
Seitenansicht openHB Sitemap
Auswertung Beispiel mit Grafana
| Qty | Value | Footprint | References |
|---|---|---|---|
| 1 | Conn_01x05_Pin | Connector_PinHeader_2.54mm:PinHeader_1x05_P2.54mm_Vertical | J1 |
| 1 | WeMos_D1_mini | Module:WEMOS_D1_mini_light | U1 |

nkitanov/iaq_board
IAQ Board is a DIY (Do-It-Yourself) device for measuring internal air quality

bitfixer/bf-romulator
Romulator - RAM/ROM replacement and debug for 6502 CPU systems

alcar21/WemosEM
Cheap power monitor (STC013) with Home Assistant Discover and Wemos D1 Mini / PRO (esp8266)

kholia/Easy-Digital-Beacons-v1
A simple and easy Arduino / Pi Pico / ESP8266-powered WSPR, FT8, and FT4 beacon system which uses NTP + DS3231 RTC for timing. Super extensible! Now comes with optional GPS support.

htumanyan/navien
Navien water heater wire protocol for communication with NaviLink and other attached devices


It measures 45.7 × 43.2 mm and has 2 copper layers, 1.6 mm thick.
2 parts, built around the WEMOS D1 MINI. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the ene9ba/IoT-ETA-Gateway repository on GitHub, at the commit this page was made from: the board is Hardware/ETA-Serial2MQTTGateway/ETA-Serial2MQTTGateway.kicad_pcb and its schematic Hardware/ETA-Serial2MQTTGateway/ETA-Serial2MQTTGateway.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the MIT licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).