
RibbonCable MB BreakdownBoard
darknode/cr-10s-pro-mods
Hardware modifications for CR-10S Pro 3D printer

Hardware modifications for CR-10S Pro 3D printer
Transfer Board is an open-source printed circuit board by darknode, from the darknode/cr-10s-pro-mods repository on GitHub. It is a 2-layer board of 51 × 53 mm with 14 parts on 26 nets, routed with 156 tracks and 0 vias.
It belongs with the robots and motor control boards of this library.
Ts is "pig tail" soldering oriented, semi compatible with original transfer board, but fully compatible with Transfer board. Has dedicated 4-wire connection for BLTouch and 3-wire connector for LED.

| Qty | Value | Footprint | References |
|---|---|---|---|
| 4 | Conn_01x02 | Connector_JST:JST_XH_B2B-XH-A_1x02_P2.50mm_Vertical | HEAT_FAN, PART_FAN, TH, X_MIN |
| 3 | Conn_01x04 | Connector_JST:JST_XH_B4B-XH-A_1x04_P2.50mm_Vertical | BL_TOUCH, MOTOR_E, MOTOR_X |
| 2 | Conn_01x03 | Connector_JST:JST_XH_B3B-XH-A_1x03_P2.50mm_Vertical | FIL_SENS, LED |
| 1 | Conn_01x02 | Connector_JST:JST_VH_B2P-VH-B_1x02_P3.96mm_Vertical | HEAT |
| 1 | Conn_02x15_Odd_Even | Connector_IDC:IDC-Header_2x15_P2.54mm_Horizontal | RIBBON1 |
The 11 most common of 14 parts.

darknode/cr-10s-pro-mods
Hardware modifications for CR-10S Pro 3D printer

darknode/cr-10s-pro-mods
Hardware modifications for CR-10S Pro 3D printer

google/mozc-devices
Circuit diagrams and firmware source code for Gboard DIY keyboards


hackclub/OnBoard
💡 Join 1,000 teenagers and make your first PCB with a $100 grant!



Twotoz/C5VRX
Ultra-minimal, zero-CPU 5.8 GHz analog FPV video receiver using ESP32-C5 Wi-Fi 6 PHY MODEM_DIAG, BitScrambler WBFM demodulation & resistor DAC CVBS


It measures 51 × 53 mm and has 2 copper layers, 1.6 mm thick.
14 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the darknode/cr-10s-pro-mods repository on GitHub, at the commit this page was made from: the board is Transfer_Board/Transfer_Board.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask darknode before reusing the design.