
Baloon
kajusK/Picoballoon2020
Probe for Observatory and Planetarium Brno Picoballoon Challenge 2020

Beambot module that hops the motor when the capacitor is charged enough.
Beamhop is an open-source printed circuit board by RoboticsBrno, from the RoboticsBrno/RB0009-Beam-Hop repository on GitHub, published under the CC0-1.0 licence. It is a 2-layer board of 31.5 × 21.5 mm with 14 parts on 8 nets, routed with 40 tracks and 0 vias.
It is built around the MCP101-270DI/TO, 1N4148W and BC847. Its parts include 2 resistors, 1 capacitor, 1 IC, 1 diode and 1 transistor.
Beambot module that hops the motor when the capacitor is charged enough.
Taken from https://www.instructables.com/Tiny-Solar-Powered-Light-Seeking-BEAM-Bot-Mini-Pho/
Two instances are typically required for one bot.

| Qty | Value | Footprint | References |
|---|---|---|---|
| 8 | MountingHole_Pad | Connector_Wire:SolderWire-0.5sqmm_1x01_D0.9mm_OD2.1mm | H1, H2, H3, H4, H5, H6, H7, H8 |
| 2 | 100 | Resistor_SMD:R_0603_1608Metric | R1, R2 |
| 1 | 1N4148W | Diode_SMD:D_SOD-123 | D1 |
| 1 | 470p | Capacitor_SMD:C_0603_1608Metric | C1 |
| 1 | BC847 | Package_TO_SOT_SMD:SOT-23 | Q1 |
| 1 | MCP101-270D | Package_TO_SOT_SMD:SOT-23 | U1 |

kajusK/Picoballoon2020
Probe for Observatory and Planetarium Brno Picoballoon Challenge 2020

andykarpov/karabas-pro
FPGA based retrocomputer with FDD and HDD controllers

golioth/elixir-hw
An open source hardware device that has cellular, wifi, bluetooth, GPS, and more!

UzixLS/zxevo1010-board
10x10cm PCB variant of ZX-Evolution project for G738/G706 enclosure



Pakequis/Chaos_papagali
A annoying device that imitates the vibration of a phone

It measures 31.5 × 21.5 mm and has 2 copper layers, 1.6 mm thick.
14 parts, built around the MCP101-270DI/TO, 1N4148W and BC847. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the RoboticsBrno/RB0009-Beam-Hop repository on GitHub, at the commit this page was made from: the board is beamhop/beamhop.kicad_pcb and its schematic beamhop/beamhop.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the CC0-1.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).