
Ardumower mega shield svn
Ardumower/ardumower
Develop an open source robotic lawn mower (HW+SW reference platform)

Hardward addon for the Raspberry Pi
RaspberryPiHat is an open-source printed circuit board by ARHollisSr, from the ARHollisSr/RaspberryPiHat repository on GitHub, published under the MIT licence. It is a 2-layer board of 27.9 × 19.3 mm with 11 parts on 18 nets, routed with 68 tracks and 2 vias.
It is built around the DHT22. Its parts include 4 resistors, 2 diodes, 1 IC, 1 connector and 1 switch.
Hardward addon for the Raspberry Pi
| Qty | Value | Footprint | References |
|---|---|---|---|
| 2 | 10kΩ | Resistor_SMD:R_0805_2012Metric | R1, R2 |
| 2 | 330Ω | Resistor_SMD:R_0805_2012Metric | R3, R4 |
| 2 | LED | LED_SMD:LED_0805_2012Metric | D1, D2 |
| 1 | DHT22 | Connector_PinHeader_2.54mm:PinHeader_1x04_P2.54mm_Vertical | U1 |
| 1 | LOGO | KiCad Graphics:3HitComboLogoInverted | G*** |
| 1 | Raspberry_Pi_2_3 | Connector_PinHeader_2.54mm:PinHeader_2x08_P2.54mm_Vertical | J1 |
| 1 | SW_DPST | freetronics_footprints:SW_PUSHBUTTON_PTH | SW1 |
The 10 most common of 11 parts.

Ardumower/ardumower
Develop an open source robotic lawn mower (HW+SW reference platform)

mcbittech/souliss-smart-thermostat-WiFi
ESP8266 WiFi Smart Thermostat based on Souliss IoT Framework

justinmklam/iot-sourdough-starter-monitor
Tracking the fermentation of sourdough starter over the cloud.

MakersAsylumIndia/M19O2
M19O2 open source hardware Oxygen Concentrator based on the Pressure Swing Adsorption cycle aka Skarstorm cycle

kbx81/ClimateSprinklerController
ESP32-based climate and sprinkler controller for use with ESPHome

felixwittwer/homeassistant_automaic_greenhouse
A cool Project to make your greenhouse smart. What about automaic irrigation and collecting enviromental data right from your garden.

AnaviTechnology/anavi-thermometer
WiFi Smart Thermometer with ESP8266, DHT22, DS18B20, OLED display and slots for up to 3 I2C sensor modules

Finomnis/AirQualitySensor
Simple Air Quality sensor based on nRF52840, Zigbee, AM2302/DHT22 and Senseair S8
It measures 27.9 × 19.3 mm and has 2 copper layers, 1.6 mm thick.
11 parts, built around the DHT22. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the ARHollisSr/RaspberryPiHat repository on GitHub, at the commit this page was made from: the board is RaspberryPiHat.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the MIT licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).