
LogicAnalyzer
gusmanb/logicanalyzer
24 channel, 100Msps logic analyzer hardware and software

A simple routing pcb to connect a TAG 6pin cable to different programers
Tag connect adaptor is an open-source printed circuit board by yiancar, from the yiancar/Tag_connect_adaptor repository on GitHub, published under the MIT licence. It is a 2-layer board of 108 × 93.5 mm with 10 parts on 17 nets, routed with 104 tracks and 0 vias.
Its parts include 5 connectors and 1 switch.
A simple routing PCB to connect a TAG-Connect cable to different programmers.
This is designed to use a TC2030-MCP-NL cable and route it to:
The BYPASS DIP switches can be used to disconnect a connection from the TAG cable to the programmer outputs. This way, the INPUT header can route the TAG cable to any device.

| Qty | Value | Footprint | References |
|---|---|---|---|
| 1 | BYPASS | Button_Switch_THT:SW_DIP_SPSTx06_Piano_10.8x16.8mm_W7.62mm_P2.54mm | SW1 |
| 1 | INPUT | Connector_PinHeader_2.54mm:PinHeader_1x06_P2.54mm_Vertical | J1 |
| 1 | ISP-USBASP | Connector_IDC:IDC-Header_2x05_P2.54mm_Horizontal | J3 |
| 1 | LOGO | logo:TAG_pinout | G*** |
| 1 | LOGO | logo:Programer_pinout | G*** |
| 1 | LOGO | logo:c232hm_table | G*** |
| 1 | LOGO | logo:yiancar_logo_silk | G*** |
| 1 | OUTPUT | Connector_PinHeader_2.54mm:PinHeader_1x06_P2.54mm_Vertical | J2 |
| 1 | ST-LINK CLONE | Connector_IDC:IDC-Header_2x05_P2.54mm_Horizontal | J4 |
| 1 | TAG 6 PIN | Connector_RJ:RJ12_Amphenol_54601 | J5 |

gusmanb/logicanalyzer
24 channel, 100Msps logic analyzer hardware and software

byrantech/laptop
anyon_e, a highly integrated, high end, open source laptop. Attempt the impossible.

joeycastillo/Sensor-Watch
A board replacement for the classic Casio F-91W wristwatch


OLIMEX/OLINUXINO
OLINUXINO is Open Source / Open Hardware, low cost from EUR 24 Linux Industrial grade Single Board Computer capable to operate -25+85C

rusefi/rusefi
rusefi - GPL internal combustion engine control unit

VoronDesign/Voron-Hardware
Cool Hardware designed by the Voron Design group

hoglet67/RGBtoHDMI
Bare-metal Raspberry Pi project that provides pixel-perfect sampling of Retro Computer RGB/YUV video and conversion to HDMI
It measures 108 × 93.5 mm and has 2 copper layers, 1.6 mm thick.
10 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the yiancar/Tag_connect_adaptor repository on GitHub, at the commit this page was made from: the board is tag_connect_adaptor.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the MIT licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).