
MagLev Switch
famichu/MagLev_Switch_MX
The 3D printable magnetic levitation contactless switch with the linear output hall effect sensor.

KZ650 ignition arduino nano
Plateau allumage is an open-source printed circuit board by sebou29, from the sebou29/KZ650-ignition repository on GitHub. It is a 2-layer board of 46.5 × 11.4 mm with 14 parts on 4 nets, routed with 35 tracks and 8 vias.
It is built around the A1302ELHLT-T.
KZ650 ignition arduino nano
Arduino nano ignition for four stroke engine motorcycle (KZ650) Inspired by aepl and aecp Optimized for kickstarter
| Qty | Value | Footprint | References |
|---|---|---|---|
| 4 | MountingHole_Pad | Connector_Wire:SolderWirePad_1x01_SMD_5x10mm | +5V, GND, Sensor, Sensor |
| 2 | A1302ELHLT-T | Package_TO_SOT_SMD:SOT-23W | U1, U2 |
The 6 most common of 14 parts.

famichu/MagLev_Switch_MX
The 3D printable magnetic levitation contactless switch with the linear output hall effect sensor.

google/mozc-devices
Circuit diagrams and firmware source code for Gboard DIY keyboards


hackclub/OnBoard
💡 Join 1,000 teenagers and make your first PCB with a $100 grant!



Twotoz/C5VRX
Ultra-minimal, zero-CPU 5.8 GHz analog FPV video receiver using ESP32-C5 Wi-Fi 6 PHY MODEM_DIAG, BitScrambler WBFM demodulation & resistor DAC CVBS

It measures 46.5 × 11.4 mm and has 2 copper layers, 1.6 mm thick.
14 parts, built around the A1302ELHLT-T. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the sebou29/KZ650-ignition repository on GitHub, at the commit this page was made from: the board is PCB/plateau/plateau allumage.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask sebou29 before reusing the design.