
Type d
google/mozc-devices
Circuit diagrams and firmware source code for Gboard DIY keyboards

Hardware and Firmware for the OzLockCon2017 Badge
Badge is an open-source printed circuit board by peterfillmore, from the peterfillmore/OzLockConBadge2017 repository on GitHub, published under the Unlicense licence. It is a 2-layer board of 52.8 × 45.1 mm with 14 parts on 10 nets, routed with 172 tracks and 6 vias.
Its parts include 4 resistors, 4 diodes, 1 capacitor, 1 IC and 1 connector. It belongs with the lEDs and displays boards and the AVR (ATmega, ATtiny) boards of this library.
Hardware and Firmware for the OzLockCon2017 Badge
Derived from the uDuck: https://github.com/insecurityofthings/uDuck - as you can probably tell from the source code.
The hardware may support the uDuck firmware as the circuit is based off it - but i screwed something up and it doesn't want to work. Ran out of time to debug so focused on the flashy flashy.
don't solder the USB connector onto the badge until you check the pin out! i screwed up and reversed the pads on the footprint - again...
| Qty | Value | Footprint | References |
|---|---|---|---|
| 2 | 68 | Resistors_SMD:R_0805_HandSoldering | R2, R3 |
| 2 | LED | OzLockCon:LED_3528 | D1, D2 |
| 2 | ZENER | Diodes_SMD:D_SOD-323_HandSoldering | D3, D4 |
| 1 | OzLockCon:OzLockConLogo | ||
| 1 | 0.1uF | Capacitors_SMD:C_0805_HandSoldering | C1 |
| 1 | 1.5k | Resistors_SMD:R_0805_HandSoldering | R1 |
| 1 | 10k | Resistors_SMD:R_0805_HandSoldering | R4 |
| 1 | ATTINY85-S | SMD_Packages:SOIC-8-N | IC1 |
| 1 | Battery | OzLockCon:CR2032_SMD | BT1 |
| 1 | SW_PUSH | Buttons_Switches_SMD:SW_SPST_PTS645 | SW1 |
| 1 | USB_A | OzLockCon:USB_A_SMD | P1 |

google/mozc-devices
Circuit diagrams and firmware source code for Gboard DIY keyboards


hackclub/OnBoard
💡 Join 1,000 teenagers and make your first PCB with a $100 grant!



Twotoz/C5VRX
Ultra-minimal, zero-CPU 5.8 GHz analog FPV video receiver using ESP32-C5 Wi-Fi 6 PHY MODEM_DIAG, BitScrambler WBFM demodulation & resistor DAC CVBS


It measures 52.8 × 45.1 mm and has 2 copper layers, 1.6 mm thick.
14 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the peterfillmore/OzLockConBadge2017 repository on GitHub, at the commit this page was made from: the board is hardware/Badge.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the Unlicense licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).