
EEZ PSU consolidated r5B13a
eez-open/psu-hw
EEZ H24005 programmable bench power supply (powered by Arduino Due)

Firmware for sinus generator SG-420M
Wh1602s is an open-source printed circuit board by pashamray, from the pashamray/SG-420M repository on GitHub, published under the GPL-3.0 licence. It is a 2-layer board of 69.2 × 44.5 mm with 19 parts on 25 nets, routed with 151 tracks and 4 vias.
It is built around the BAS316. Its parts include 4 diodes, 4 switches, 2 resistors, 1 capacitor and 1 IC. It belongs with the AVR (ATmega, ATtiny) boards of this library.
Прошивка модифицирована для работы с экранами на контроллере HD44780, размером 16x2, такими как WH1602. Подключение экрана аналогично подключению в частотомере FC-510



Ридико Леонид Иванович
| Qty | Value | Footprint | References |
|---|---|---|---|
| 4 | BAS316 | Diodes_SMD:D_SOD-323 | D1, D2, D3, D4 |
| 1 | 100n | Capacitors_SMD:C_0805 | C1 |
| 1 | 10K | Potentiometers:Potentiometer_Trimmer_Bourns_3296W | RV1 |
| 1 | 1K | Resistors_SMD:R_0805 | R1 |
| 1 | 50R | Resistors_SMD:R_0805 | R2 |
| 1 | 74164 | SMD_Packages:SOIC-14_N | U1 |
| 1 | CONN_01X06 | Socket_Strips:Socket_Strip_Straight_1x06_Pitch2.54mm | J1 |
| 1 | DOWN | Buttons_Switches_THT:SW_PUSH-12mm | SW2 |
| 1 | MENU | Buttons_Switches_THT:SW_PUSH-12mm | SW1 |
| 1 | OK | Buttons_Switches_THT:SW_PUSH-12mm | SW4 |
| 1 | UP | Buttons_Switches_THT:SW_PUSH-12mm | SW3 |
| 1 | WH1602S | winstar:WH1602S | LCD1 |
The 15 most common of 19 parts.

eez-open/psu-hw
EEZ H24005 programmable bench power supply (powered by Arduino Due)





Squantor/DiySolderingStation
Do it yourself soldering station


TUDSSL/densor
Densor is an intraoral sensor platform, attached to regular dental retainers or aligners, that can take measurements inside the mouth.
It measures 69.2 × 44.5 mm and has 2 copper layers, 1.6 mm thick.
19 parts, built around the BAS316. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the pashamray/SG-420M repository on GitHub, at the commit this page was made from: the board is hardware/kicad/wh1602s/wh1602s_.kicad_pcb. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the GPL-3.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).