
BandSelector
n1kdo/BandSelector
IOT BandSelector (also known as a Band Decoder) works with Antenna Switch Controller to perform automated antenna selection on band change

IOT BandSelector (also known as a Band Decoder) works with Antenna Switch Controller to perform automated antenna selection on band change
Display board is an open-source printed circuit board by n1kdo, from the n1kdo/BandSelector repository on GitHub. It is a 2-layer board of 88 × 32 mm with 14 parts on 20 nets, routed with 119 tracks and 5 vias.
Its parts include 4 switches, 1 capacitor, 1 resistor, 1 IC and 1 connector. It belongs with the radio and wireless and lEDs and displays boards and the RP2040 boards of this library.
This is a carrier for a 2x20 LCD display. It has 4 pushbuttons that are pull-to-ground.
The module is intended to mount in the front part of the cover of a Hammond 1591XXSFLBK enclosure. Note that I have not actually tried this yet.
The board has a cut-out for the visible part of the display, and holes marking all the pushbutton actuators. The intent is that a bare board can be used as a template to mark the enclosure for drilling.
3d mockup from Kicad:

Prototype 1:

Design PDFs
| Qty | Value | Footprint | References |
|---|---|---|---|
| 4 | MountingHole | Library:MountingHole_4-40 | H1, H2, H3, H4 |
| 4 | SW_Push | Library:SKHHQNA010 | SW1, SW2, SW3, SW4 |
| 1 | 10000 | Library:N6L50T0C103 | RV1 |
| 1 | 1uF | Capacitor_THT:CP_Radial_D5.0mm_P2.50mm | C1 |
| 1 | 220 | Resistor_THT:R_Axial_DIN0207_L6.3mm_D2.5mm_P7.62mm_Horizontal | R1 |
| 1 | Conn_01x16 | Library:22288160 | J1 |
| 1 | Non-Ionizing | Library:non-ionizing-bigger | G1 |
| 1 | ~ | Library:NHD-0220FZW-GBW-P-33V3 | U1 |

n1kdo/BandSelector
IOT BandSelector (also known as a Band Decoder) works with Antenna Switch Controller to perform automated antenna selection on band change

google/mozc-devices
Circuit diagrams and firmware source code for Gboard DIY keyboards


hackclub/OnBoard
💡 Join 1,000 teenagers and make your first PCB with a $100 grant!



Twotoz/C5VRX
Ultra-minimal, zero-CPU 5.8 GHz analog FPV video receiver using ESP32-C5 Wi-Fi 6 PHY MODEM_DIAG, BitScrambler WBFM demodulation & resistor DAC CVBS


It measures 88 × 32 mm and has 2 copper layers, 1.6 mm thick.
14 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the n1kdo/BandSelector repository on GitHub, at the commit this page was made from: the board is kicad/DisplayBoard/display-board.kicad_pcb and its schematic kicad/BandSelector/BandSelector.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask n1kdo before reusing the design.