Macrodeck

Streamdeck copy kinda???

Hello this is my copy of a streamdeck that can do shortcuts, hotkeys, and maybe like a soundboard maybe later.

Devlog #1

My frist devlog is just the schematic of the pcb however maybe I might cange a few things but right now its fine. mybey colume control may benfit me in some way however im not sure

Devlog #2

i managed to do many things today. for starters I was able to model the pcb of the actual schematic and I did eventually add a rotary encoder for volume control however this was a pain in the butt because to figure out how the rotary encoder should connect to the seed studio. anyways, I did also make the 3d model of the cade that the board would fit into and at the time of writing this its cirrently printing on my 3d printer.

Devlog #3

no image today but the case came out looking great but i think i mesured the pcb wrong because it looked a little small for hot sawp switches to fit but I dont know. Also I managed to get the code in a beta but I have no idea how to code and I am still looking at learning about that so I asked the github guy for help

Devlog #4

I have now finished everything needed to puch my first project!! Above it the final parts for the the building faze of my macrodeck.

if you wanna copy here is a Setup Guide

Setup

1. Copy main.py onto your RP2040 board running CircuitPython.
2. Adjust KEY_PINS, encoder pins, and KEY_ACTIVE_HIGH in main.py to match your wiring.
3. Install PySerial and Keyboard on your PC:

python -m pip install pyserial

python -m pip install keyboard

4. Run the host UI:

python host_ui.py

Host UI commands

• s: request current state
• r: reset encoder position
• d: toggle debug reporting
• h: show help
• q: quit