ESPSK6812Driver

LumiLeaf

Smart affordable adressable LED panels

Assembly

Step 1

Remove the printed supports and adhesion materials from the part.

Step 2

Use a soldering iron to insert the 4 terminal heatset inserts.

Insert the M3 terminal bolts and washers into the inserts.

Step 3

Strip a length of solid core ethernet cable.

Separate the individual strands, and remove the twists as much as possible.

Step 4

Route the wires through the wire channel as shown.

Step 5

Cut a 250mm length of LED strip.

Adhere this around the edge of the light.

Step 6

Carefully solder the 4 wires to the 5V, GND, D+ and D- pins. This is very fiddly, and may require multiple attempts.

Step 7

Route the wires out the wire hole, and spread them to each of their terminals.

Loop each wire around a bolt and tighten, ensuring there is no insulation clamped under the screw.

Step 8

Use a multimeter to check check for short circuts in the assembly.

Step 9

Cut out a triangular section of foil to act as the reflector.

Use a thin double sided tape to adhere the foil over the back panel.

[!WARNING] Ensure the foil does not make contact with the LED strip or exposed wire. This could lead to a short circut!

Step 10

Repeat for all other desired modules. Attach the lasercut or 3D printed diffuser and bezel.