
Passive rpi hub75-adapter
hzeller/rpi-rgb-led-matrix
Controlling up to three chains of 64x64, 32x32, 16x32 or similar RGB LED displays using Raspberry Pi GPIO

Useful information and mods for the HORI Dragon Quest PS2 Controller
DQ PS2 Controller Adapter is an open-source printed circuit board by jeffqchen, from the jeffqchen/HORI-DQ-PS2-Controller-Resource repository on GitHub, published under the CC-BY-SA-4.0 licence. It is a 2-layer board of 39 × 18.9 mm with 2 parts on 9 nets, routed with 26 tracks and 0 vias.
It belongs with the interfaces and adapters boards of this library.
I have bought two of the HORI Dragon Quest PlayStation 2 controllers without the base and the cable. I've been meaning to create those on my own over the years. Finally, I've made it happen.
I've observed photos from the internet and created this base from the impression. It is not 100% accurate but is very close.
This controller has a non-standard Mini DIN 8 pin connector. To connect to the PS2, you must use the enclosed cable. Without the cable, this controller is unusable.
This adapter follows the asthetics of the official controller plug, and does not intefere with the memory card.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 1 | Mini-DIN-8 | DQ PS2 Controller Adapter:Mini DIN 8Pin THT | J1 |
| 1 | PSXConnector | DQ PS2 Controller Adapter:PSXController | P1 |

hzeller/rpi-rgb-led-matrix
Controlling up to three chains of 64x64, 32x32, 16x32 or similar RGB LED displays using Raspberry Pi GPIO


adamws/kicad-kbplacer
KiCad plugin for automatic keyboard's key placement and routing

Luos-io/luos_engine
Open-source and real-time orchestrator for cyber-physical-systems, to easily design, test and deploy embedded applications and digital twins.

NVNTLabs/switch2-SDEX2M2
Micro SD Express to M.2 NVME Adapter for Nintendo Switch 2

BlueSCSI/BlueSCSI-v2
BlueSCSI v2/Ultra - an open source, open hardware, SCSI emulator using the Pi Pico PR2040 and Pico 2 RP2350

ohmtech-rdi/eurorack-blocks
Software to Hardware Prototyping for Eurorack using C++, Max/Gen~ or Faust

It measures 39 × 18.9 mm and has 2 copper layers, 1.6 mm thick.
2 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the jeffqchen/HORI-DQ-PS2-Controller-Resource repository on GitHub, at the commit this page was made from: the board is Mini DIN to PS Plug Adapter/PCB/DQ PS2 Controller Adapter.kicad_pcb and its schematic Mini DIN to PS Plug Adapter/PCB/DQ PS2 Controller Adapter.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository publishes it under the CC-BY-SA-4.0 licence: you may reuse it on that licence's terms (keep the author's notice, and for a copyleft licence share your changes alike).