
Gain box psu pcb
carmisergio/denon-preout-mod
PCB designs and firmware for the Denon AVR-X1300W Pre-out mod

PCB designs and firmware for the Denon AVR-X1300W Pre-out mod
Vampire pcb is an open-source printed circuit board by carmisergio, from the carmisergio/denon-preout-mod repository on GitHub. It is a 2-layer board of 68.5 × 22.3 mm with 3 parts on 9 nets, routed with 20 tracks and 8 vias.
The scope of this project is adding line-level outputs to the Denon AVR-X1300W AV Receiver. This can be acheived by getting the low-level signals from the digital board of the receiver before they make their way to the power amp board.
The "Vampire PCB" is soldered directly to the digital board of the receiverr, and provides an 8-pin JST PH connector with the signals. A small length of shielded cable brings them to the back panel of the unit, where removing the AM/FM tuner unit provides a convenient place to mount a miniature circular connector.
An external "Gain Box" amplifies the ~150Vrms internal signal to a usable (variable) line level with a single stage of op-amp amplification. It also processes the 12V signal coming from the receiver to operate muting relays on the output and generate a standard 12V trigger signal which can be used to control the amplifiers.
| Qty | Value | Footprint | References |
|---|---|---|---|
| 1 | Conn_01x08 | Connector_JST:JST_PH_B8B-PH-K_1x08_P2.00mm_Vertical | J1 |
| 1 | GND_PAD | TestPoint:TestPoint_Pad_4.0x4.0mm | J3 |
| 1 | VAMPIRE_EDGE | Connector_PinSocket_2.54mm:PinSocket_1x08_P2.54mm_Vertical | J2 |

carmisergio/denon-preout-mod
PCB designs and firmware for the Denon AVR-X1300W Pre-out mod

carmisergio/denon-preout-mod
PCB designs and firmware for the Denon AVR-X1300W Pre-out mod


hzeller/rpi-rgb-led-matrix
Controlling up to three chains of 64x64, 32x32, 16x32 or similar RGB LED displays using Raspberry Pi GPIO


atopile/atopile
Design circuit boards with code! ✨ Get software-like design reuse 🚀, validation, version control and collaboration in hardware; starting with electronics ⚡️




hackclub/sprig
🍃 Learn to code by making games in a JavaScript web-based game editor.
It measures 68.5 × 22.3 mm and has 2 copper layers, 1.6 mm thick.
3 parts. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the carmisergio/denon-preout-mod repository on GitHub, at the commit this page was made from: the board is vampire_pcb/kicad_project/vampire_pcb.kicad_pcb and its schematic gain_box_amp_pcb/kicad_project/gain_box_amp_pcb.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask carmisergio before reusing the design.