
RadarAdapter
Brazil-L/Lumeward-OpenSource
Open-source Lumeward firmware and development tools

My take on the classic JTAG/SWD dongle board for debuging probes. I mostly use it with the 10-pins 1.27mm connector to flash and debug ARM MCUs.
JTAG dongle is an open-source printed circuit board by Sebastien-Monfort, from the Sebastien-Monfort/JTAG_dongle repository on GitHub. It is a 2-layer board of 52.7 × 31.8 mm with 54 parts on 73 nets, routed with 144 tracks and 51 vias.
It is built around the FTS-105-01-F-DV. It belongs with the interfaces and adapters boards of this library.
My take on the classic JTAG/SWD dongle board for debuging probes. I mostly use it with the 10-pins 1.27mm connector to flash and debug ARM MCUs.
I added a few solder jumpers on signal lines in case of layout error.

| Qty | Value | Footprint | References |
|---|---|---|---|
| 49 | SolderJumper_2_Bridged | Jumper:SolderJumper-2_P1.3mm_Bridged_Pad1.0x1.5mm | JP1, JP2, JP10, JP11, JP12, JP13, JP14, JP15, JP16, JP17, JP18, JP19, JP20, JP21, JP22, JP23 +33 |
| 1 | 5V supply Enable | Connector_PinHeader_2.54mm:PinHeader_1x02_P2.54mm_Vertical | J1 |
| 1 | Conn_02x10_Odd_Even | Connector_PinHeader_2.54mm:PinHeader_2x10_P2.54mm_Vertical | J3 |
| 1 | FTS-105-01-F-D | Connector_PinHeader_1.27mm:PinHeader_2x05_P1.27mm_Vertical | J4 |
| 1 | LOGO | LOGO | G*** |
| 1 | SeggerJlink connector | local_footprints:SeggerJlinkFemaleConn | J2 |

Brazil-L/Lumeward-OpenSource
Open-source Lumeward firmware and development tools



MaltWhiskey/Mega-Cube
16x16x16 PL9823 Cube with Teensy 4.0 and FlexIO driver




It measures 52.7 × 31.8 mm and has 2 copper layers, 1.6 mm thick.
54 parts, built around the FTS-105-01-F-DV. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
From the Sebastien-Monfort/JTAG_dongle repository on GitHub, at the commit this page was made from: the board is JTAG_dongle.kicad_pcb and its schematic JTAG_dongle.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Its repository states no licence, so its author keeps all rights: ask Sebastien-Monfort before reusing the design.