

FrostyThePCBMan
Final project for Embedded Systems Fall 2025
- Size
- 48.9 × 42 mm
- Copper layers
- 4
- Thickness
- 1.6 mm
- Parts
- 52
- Nets
- 83
- Pads
- 243
- Tracks, vias
- 776, 129
- Pours
- 2
- Routed
- Yes
- KiCad
- KiCad 9.0 (file 20241229)
- Created
- 8 Dec 2025
- Updated
- 11 Dec 2025
Overview
FrostyThePCBMan is an open-source printed circuit board by 1112luke, from the 1112luke/FrostyThePCBMan repository on GitHub. It is a 4-layer board of 48.9 × 42 mm with 52 parts on 83 nets, routed with 776 tracks and 129 vias.
It is built around the RP2040, GPS02-UBX and W25Q128JVSIQ, with the AP2112K-3.3, 1N5819WS and AO3401A among its other parts. Its parts include 20 capacitors, 13 resistors, 5 ICs, 5 connectors and 4 diodes. It belongs with the RP2040 boards of this library.
Main components
6RP2040
LQFN-56(7x7)12bit 133MHz 30 LQFN-56(7x7) Microcontrollers (MCU/MPU/SOC) ROHSRaspberry PiMicrocontrollers (MCU/MPU/SOC)GPS02-UBX
SMD,16.5x14.5mm-166dBm -40℃~+85℃ 2.7V~3.6V 25mA@3.3V 28s 3m GPS、BDS、GLONASS、GALILEO UART、I2C SMD,16.5x14.5mm GNSS Modules ROHSG-NiceRFGNSS ModulesW25Q128JVSIQ
SOIC-8-208mil-40℃~+85℃ 100,000 cycles 120ms@(32KB) 128Mbit 133MHz 1uA 2.7V~3.6V 20 Years 3ms Power-on reset、Hardware write protection、Software write protection、Write enable latch、Absolute write protection SPI SOIC-8-208mil NOR FLASH ROHSWinbondNOR FLASHAP2112K-3.3
SOT253.3V 600mA CMOS Low Dropout Linear Regulator with EnableDiodes IncorporatedUncategorised1N5819WS
SOD-3231 Independent 1A 25A 40V 500uA@40V 600mV@1A SOD-323 Schottky Diodes ROHSGuangdong HottechSchottky DiodesAO3401A
SOT-231 P-Channel 14nC@10V 30V 47mΩ@10V、60mΩ@4.5V、85mΩ@2.5V 4A 55pF 645pF 80pF 900mV SOT-23 MOSFETs ROHSAlpha & Omega SemiconductorMOSFETs
README
README.mdFrosty The PCB Man
Final Project for Embedded Systems Fall 2025
Parts
52| Qty | Value | Footprint | References |
|---|---|---|---|
| 14 | 100nF | Capacitor_SMD:C_0402_1005Metric | C3, C4, C6, C7, C9, C10, C11, C12, C13, C15, C16, C17, C18, C21 |
| 5 | 10k | Resistor_SMD:R_0402_1005Metric | R1, R6, R9, R10, R13 |
| 4 | 1uF | Capacitor_SMD:C_0402_1005Metric | C5, C8, C19, C20 |
| 2 | 1k | Resistor_SMD:R_0402_1005Metric | R2, R5 |
| 2 | 22pF | Capacitor_SMD:C_0402_1005Metric | C1, C2 |
| 2 | 27 | Resistor_SMD:R_0402_1005Metric | R3, R4 |
| 2 | 4.7k | Resistor_SMD:R_0402_1005Metric | R11, R12 |
| 2 | 5.1k | Resistor_SMD:R_0402_1005Metric | R7, R8 |
| 2 | Conn_Coaxial | Connector_Coaxial:U.FL_Hirose_U.FL-R-SMT-1_Vertical | J1, J2 |
| 2 | LED_WHITE | LED_SMD:LED_0603_1608Metric | D3, D4 |
| 2 | SW_Push | Button_Switch_SMD:SW_SPST_SKQG_WithStem | SW1, SW2 |
| 1 | 1N5819WS | Diode_SMD:D_SOD-323 | D1 |
| 1 | AO3401A | Package_TO_SOT_SMD:SOT-23 | Q1 |
| 1 | AP2112K-3.3 | Package_TO_SOT_SMD:SOT-23-5 | U5 |
| 1 | Ai-Thinker-Ra-01 | RF_Module:Ai-Thinker-Ra-01-LoRa | U3 |
| 1 | Battery_Cell | Battery:BatteryHolder_Multicomp_BC-2001_1x2032 | BT1 |
| 1 | Conn_01x02_MountingPin | Connector_JST:JST_PH_S2B-PH-SM4-TB_1x02-1MP_P2.00mm_Horizontal | J3 |
| 1 | Conn_01x04_MountingPin | Connector_JST:JST_SH_SM04B-SRSS-TB_1x04-1MP_P1.00mm_Horizontal | J5 |
| 1 | Crystal_GND24 | Crystal:Crystal_SMD_3225-4Pin_3.2x2.5mm | Y1 |
| 1 | GPS02-UBX | GPS:QFN-20_14.5x16.45_Pitch1.8mm | U4 |
| 1 | LED_RED | LED_SMD:LED_0603_1608Metric | D2 |
| 1 | RP2040 | Package_DFN_QFN:QFN-56-1EP_7x7mm_P0.4mm_EP3.2x3.2mm_ThermalVias | U1 |
| 1 | USB_C_Receptacle_USB2.0_16P | Connector_USB:USB_C_Receptacle_HCTL_HC-TYPE-C-16P-01A | J4 |
| 1 | W25Q128JVS | Package_SO:SOIC-8_5.3x5.3mm_P1.27mm | U2 |
Similar boards
- 4 layers37.3 × 39 mm

- 4 layers37.2 × 52.3 mm

- 6 layers42.8 × 66.3 mm

Plant Monitor
C-yue28/Plant-Monitor
ML-powered plant monitor, tracking metrics such as temperature, humidity, soil moisture, etc to inform plant watering behavior.
59 parts - 2 layers312.5 × 122.3 mm

- 4 layers76 × 50 mm

Wigglecam
jadenrhee/wigglecam-controller
RP2040 co-processor board for a 4-lens wigglegram camera: constant-current flash, controls, battery telemetry, Pi 5 I2C interface. 4-layer, DRC-clean, fab-ready.
105 parts - 2 layers97.6 × 67.3 mm

- 4 layers54.7 × 78.5 mm

DisplayModule PONSv71
MasaoC/GPS-TFT-Map_PONS
鳥人間コンテストに特化したGNSS誘導システム。人力飛行機のパイロットが使いやすいことを目標にした航法装置です。ハードとソフトをオープンソースで開発しています。
151 parts14MIT - 2 layers31.3 × 67 mm

Questions
How big is the FrostyThePCBMan PCB?
It measures 48.9 × 42 mm and has 4 copper layers, 1.6 mm thick.
What parts does the FrostyThePCBMan use?
52 parts, built around the RP2040, GPS02-UBX, W25Q128JVSIQ and AP2112K-3.3. The full list of its parts is on this page, with links to each part's symbol and footprint where PCBKit's library has them.
Where can I download the FrostyThePCBMan KiCad files?
From the 1112luke/FrostyThePCBMan repository on GitHub, at the commit this page was made from: the board is Final.kicad_pcb and its schematic Final.kicad_sch. PCBKit opens the board in the browser, with nothing to install.
Can I use the FrostyThePCBMan design in my own project?
Its repository states no licence, so its author keeps all rights: ask 1112luke before reusing the design.